Nice ride Jeff,
engine compartment looks just like mine. Did you have any trouble with the heater hose sleeves? It looks like you left off the end peice at the pump & intake fittings. I say that 'cause that's what I had to do, the clamps that came in the kit just keep on spinning w/out tightening up.
BTW, I put a 90 degree elbow on the intake to attach the hose to, it brings the hose down closer to the other heater hose sooner. Looks a little cleaner. I bought it at NAPA.
Bill A.
______________
EdelBrock Performer w/ 750 doub pumper,port/polished heads, triple cut valves w/4th cut down the throat of the exhaust valves, 286 Comp Magnum cam, 1.6 roller rockers, ball-peen pushrods w/guides, screw in rocker studs w/girdles, Comp double-roller chain, , hi-rise valves covers w/ spacer (needed for the girdles), Flowtech by Holley long-tube ceramic coated headers into Stage II pipes (no cats), chrome wire looms for the MSD 8.5 mm wires, MSD 50,000v coil kit w/advance springs, cap, rotor, module, steel-braided radiator,heater,vacuum hoses, Infinity Kappa 4x6 plates (dash), Sony Xplode 6 3/4" (rear), chrome T-stat housing, A-arm shields, B&M Hammerhead shifter
|IMG||/IMG|