I'm having a difficult time trying to assemble all new hoses that go into the water heat valave and then into the heater core. i have a 71 LS5 454 with AC (C60).
HC=heater core
HCV=heater control valve
I have all new hoses and want to get this right before cutting.
I've attached a scan of the factory assembly manual C60 D6 sheet.
Large Water Pump/6 goes to the 90 degree fitting under expansion tank. That's clear in View B.
Med Intake hose/4 (slightly shaded) looks like it goes directly to HC (left pipe in pic).
The return line from HC looks to go into HCV.
I would think the intake/4 line goes into the bottom expansion tank (straight up med nipple), then to the HCV, then out to the HC. But I suppose the HC has to return the coolant somehwher, too.
I'm at a loss because when I went to "freshen" all my vacuum lines, the HCV was bypassed/disconnected- weird, I still had heat and I checked the valve it was good (pressure-wise).
The behind-the-gill area is small and hard to get to, so when I went to fix things, I swapped everything out so I'll never have to do it again. Replacing the wiper air valve and HCV with all lines and hoses.
Can anyone make out or explain the routing of big block AC heater hoses?this dia
gram