Home page
SPONSOR AD

Support our Vendors!  |  Advertise Here

Topic: Test the AC system

in Forum: C3 Cooling and Heating Systems


Already a Member?
Login
Not yet a Member?
Register for Free!

Test the AC system (1/4)
 4/19/13 11:13pm
dwright
Standard Member
Moderator
Send Private Message

Victor, NY - USA

Vette(s):
2004 Commemorative Edition Coupe, Auto w/HUD. 13K miles in 2015. Sold 1982 Red Coupe


Joined: 7/12/2004
Posts: 6833

Last Fall my AC was not pumping out cold air.
So it probably needs a re-charge.
How do I test it for leaks before I charge it?


______________
 
Save the Wave!
Support the National Corvette Museum   
Our Sponsors help support C3VR
Re: Test the AC system (2/4)
 4/20/13 10:12am
corvette440hpLifetime Member
Lifetime Member
Send Private Message

Joined: 7/2/2006
Posts: 8205

Dave, if your system happens to still have a positive pressure within itself, then mix up a soap/water solution and spray this on the fittings etc. Let the solution sit for a few minutes (at least ten). Check for bubbling. They actually make a bubble leak solution that can be purchased, but you can make your own. Also, there are professional leak detectors, but they are costly. Good luck hunting!

______________

corvette440hp
Re: Test the AC system (3/4)
 4/20/13 11:34am
Adams' AppleLifetime Member
Lifetime Member
Moderator
Send Private Message

Duncanville, TX - USA

Vette(s):
#1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/ Am-Fm/map light National/Regional/Chapter NCRS "Top Flight" #2-1985 Bright Red/Carmine Cp.L-98/auto Member: NCRS, NCRS Texas, Corvette Legends of Texas


Joined: 11/8/2003
Posts: 20126

A couple of ways.
You can charge it with nitrogen(using gauges), and let it sit and see if it looses pressure. This takes time....and access to nitrogen.

You could also evacuate the system(requires a vacuum pump and gauges), which pulls a steady vacuum on it. Depending on the pump, this will take around an hour...sometimes less. I like pulling them down for at least that long, as it eliminates any/all moisture from the system. Others have differing opinions.  It should hold the vacuum, usually around 25-30" for at least an hour after evacuating.

My first suggestion is to see if the system has a charge in it now. Unless you know for sure it has a leak, then re-charging it is kinda like putting the cart before the horse.... Put some gauges on it, and see what you're starting with. If the system is empty, or very low, then you know you have a leak. If low, then a leak detector would be the best way to find it. If empty, it will need to be charged with something to find the leak. If it has the correct pressures, then your problem is elsewhere. Gotta start with the basics. Thumbs Up


______________

Joel Adams
C3VR Lifetime Member #56    

My Link


(click for Texas-sized view!)
             NCRS

"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"

Re: Test the AC system (4/4)
 4/28/13 12:21pm
73shark
Limited Member
Send Private Message

Overland Park, KS - USA

Vette(s):
1973 Orange Metallic Coupe (orig owner), L82, 4 spd (WR), PS, (A/C & PW (I installed from wrecked 73)), leather, AM/FM Stereo, ran with '65 FI unit earlier & will again some day.


Joined: 7/9/2003
Posts: 864

Simple Green acts as a good leak detector.

You can get a relatively inexpensive vacuum pump from Harbor Freight is you decide to evacuate the system but I'd first determine if there's a leak like suggested above.

|UPDATED|4/28/2013 9:21:05 AM (AZT)|/UPDATED|


______________

1973 L-82 4 spd

Our Sponsors help support C3VR