When  I  was  solving my   starting  problem, I  found a  few  wires  that  need  to  be  plugged  in.
Does  anyone  know  where  the  mating  end  of  this plug?
These are  under  the  dash.

1.  It  says  it  the  "wiper  door  Switch  Connector"
It is  a  heavy  gauge  wire, 1 red, 1   red /white  striped

              
( I  do  not  have  a  wiper  door  )
----------------------------------------------------------------------------------------------------------------------------------

2.  Also,  I have  a  single  plug,  brown  wire,  12  ga.  ,  that  is  called  "radio  capacitor  conn.  on  Ign  switch"
(  no  pic)  What  does  this  plug  on  too?  It  does  not  look  long  enough  to  reach  the  radio   plus
I  have  no  radio at  this time.

I'm  sure  I  will  have more  tomorrow  night.

Thanks,
Joe


|UPDATED|3/7/2012 8:56:50 PM (AZT)|/UPDATED|

Tape em up, and faggeddaboutit. The one marked for the wiper door would have gone to the over-ride switch, under the steering column. The other one, for the capacitor, MAY have plugged into the fuseblock on an "IGN" terminal...not sure about that, tho. It may have had a capacitor stuck in it....

______________

Joel Adams
C3VR Lifetime Member #56    
My Link


(click for Texas-sized view!)             NCRS

"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"

their are a lot of wires on the older vettes that go nowhere. on my last tranny conversion (1969 vet from auto to 5 speed i was dreading wiring the neutral safty switch to the clutch pedal from the center console - when i got to it the wire was already there all i did was plug it in)

______________

Annicorvette
Lifetime member # 35

I'm finding that out.