Ok. Well. Due to Issues I am not going into. I have to sell my 1974 Corvette. It is in great condition. Fresh paint job on it (2 years old). The car has been on the road 6 days in the past three years. It has a fully rebuilt motor and trans and everything under the hood has been refurnished or restored to original condition. The only item that needs to be replaced is the Air conditioner as it is frozen and needs to be replaced. All The AC lines have been replaced and I even have the belt for it.
It has the stock wheels on it with the Firestone 500 tires on it which were the original tires for it in 1974.
I have re-done the hard plastics on interior and re-upholstered the seats but never replaced the rug.
Whole suspension has been replaced, Radiator and supports. virtually everything has been re-done and painted to original colors. Not a frame off car. I have spend alot of money on this car and know I won't get anything near it back.
Ok Here goes:
04/18/2013 - All new Calipers on all 4 wheels, Synthetic Oil change
02/15/2013 - New Car battery (now has slow charge cable hooked up so no more batteries needed)
04/30/2010- Powder coated rear Trailing arms, Rebuilt T-arms with all new parts and USA bearings, RH lower shock mount, Rear T-Arm bolt and SS shim kit, rear sway bar link bushings, rear strut rod bushings, Replacement rear spring, Spring to T arm mount kit, Synthetic Oil Change, Interstate car Battery (batteries die from lack of use)
04/28/2009 - Synthetic Oil change, transmission pan gasket kit, Transmission fluid, replace bolts in rear sway bar
04/11/2009 - Interstate Car Battery
05/24/2008 - Side Pipe Mounting Bolts, side pipe rubber mounting grommets, exhaust manifold donuts, oil filter, trans fluid, starter, A/C Belt, Alternator Belt, Power Steering Belt, Distributor cap, Distributor rotor, coolant, motor oil, under coating, spark plugs, radiator support bolts, radiator hold down bolts, A/C O Ring seals, Heater Hoses, Heater Hose Clamps, gas hose and clamps,
04/24/2008 - Radiator repair, flywheel, ARM seals, Fan Shroud A/C, Ignition shield set, gas line pump-carb, brake line set, strut rods, exhaust manifold studs, power window regulator, engine harness, ground cable-starter/frame, auto transcooler lines, radiator cap, A/C compressor Decal, EGR Switch, Emission Decal, Fan Shroud, Half shaft, u-jt,u-blt,nut/washer kit, Half shaft u-jt bolt locks, upgrade cam, replaces valves-intake & exhaust, main shaft, half shafts & parts, rebuilt Trans, harmonic balancing, Engine rebuild, intake manifold vacuum, Trans Control Spark Switch, steering box seal kit, steering col. coupler repair kit
04/02/2007 - Rally wheel paint, Hood insulation blanket
09/21/2006 - Installed Firestone 500 Tires
06/17/2006 - Oil change
05/12/2006 - Cup holder, upper dash pad, seat foam set, brake console, horn button, seat back panel, - I re-upholstered the seats myself and replaced the brake console and bought an armrest, new door sill plates and corvette floor mats. - Carpet still original.
02/16/2006 - New driver side Front fender, Full paint job - all details on receipt, painted original color the car was - Silver Mist
02/09/2006 - radiator core support, radiator to core& radiator to shroud seal kit, A/C Cond. mounts, trans cooler lines, radiator support cushions, Pr. Teflon O rings for condensor, Overflow hose, Horn contact w/TT, Distributor cross gear and thrust button, Anti-freeze
11/10/2005 - Flex-fit front bumper, SS fastener kit for bumper
10/10/2005 - Rear spring to T-arm mtg set, Caliper pad pins, set rear caliper mtg bolts, sprayed stock grey paint on suspension parts to original colors
09/27/2005 - Lower rad hose, upper rad hose, rear spring liners, Pr. Upper shock bolts, strut rods w/ bushings, rear caliper rebuild kits, rear caliper ss lines, car set rubber brake hoses w/washers, axle set brake pads, rear USA rotors, #4 body mount reinf, #4 body mt cage & nut, #4 body mt cushions & bolts, Rear KYB gas shocks
09/23/2005-Rebuild Original Q-Jet, 3/8 fuel line, plug kit and gasket
07/26/2005 - Oil Pan gaskets, valve cover gaskets, front seal, balancer repair kit, oil & oil filter, exhaust studs, KYB gas front shocks, P/S control valve w/ exch, P/S slave cylinder w/exch, 4 Hose set, P/S Fluid, R&R complete front end incl. bushings, ball joints, idler, tie rods, sway bar links
Asking $19,500 or best offer
I have tons of pics and can go into detail on what has been done as I kept all of the receipts. I am 4th owner. Tons of receipts of stuff done by previous owner, I have all his receipts too. I am just listing what I had done.
Hope to hear from someone soon.
Jeremy H.
|UPDATED|7/27/2013 8:43:24 AM (AZT)|/UPDATED|