I'm new to this forum and this information may already be out there. I'm trying to decide how I'm going to support the body of my 78 while restoring the frame. I've seen various videos where guys have used wood, some looked very shakey. Does anyone know of a set of plans for the dolly or know where to get them? Also, does anyone know if the doors need to be removed before lifting? Thanks
Vette(s): 70 LT1 coupe, 69 350 HP coupe, 69 390HP 427 coupe, 71 LS5 convert, 85 coupe, 93 coupe
Last question first. I would leave the doors on for more rigidity, but it is not critical. I just build three sawhorses, each the correct height for its spot. The first goes under the core support to support that long nose. The second and third go under the main body tub, one at the firewall, and one as far back as possible. That will be good for a few months.
Corvette is a registered trademark of the General Motors Corporation(GM) &
Chevrolet Motor Division. Vette Registries, LLC is responsible for all site content (except for member submitted content or where otherwise
noted) and does not claim or imply that Chevrolet or
GM is responsible for Official C3 Vette Registry content. Vette Registries, LLC is independent from GM and is not affiliated
with, sponsored or supported by GM. Copyright/trademark/sales mark
infringements are not intended, or implied and are in fact used to support
GM, Chevrolet and Corvette.
Official C3 Vette Registry content is Copyright 2001-2018, Vette Registries, LLC. Content may not be reused without written consent. All Rights Reserved. NS
Corvette (Vette) Model Years on this site: 1968 1969 1970 1971 1972 1973 1974 1975 1976 1977 1978 1979 1980 1981 1982