Need some help with the front and gas emblems. I have both new ones but have not installed them yet. I see only the gas emblems have screws but cannot find the front or do the fronts have screws. I need to know how to get these off without doing harm to the paint. Thanks for the awesome help.
Vette(s): black 1982 coupe slate gray interior, 350 crossfire, 1985 fuel pump, Steeroids R&P conversion
Ive used the fishing line technique several times with success. I think dental floss would do as well. The line cuts through the sticky tape and once the emblem is off adhesive remover does the rest of the work.
Vette(s): 1981 Great White Shark. Red Interior, 350/190hp. PS, PB (SS), A/C CC, T-Tops, Going to remain as Stock as possible. Served three years in Active Duty Army, then Retired Air Force after 34 years! Badger State Vetts Car Club. 175,000 Original miles!!
The rear emblum of the 1981 (gas cap) has a screw on type cap that holds it to the gas cap door. The front emplem is stuck on the body. I never got a "A" for my spelling abilities so I ain't goon start now!! The dental floss works good on getting it off but makes your teeth look bad!!!
Corvette is a registered trademark of the General Motors Corporation(GM) &
Chevrolet Motor Division. Vette Registries, LLC is responsible for all site content (except for member submitted content or where otherwise
noted) and does not claim or imply that Chevrolet or
GM is responsible for Official C3 Vette Registry content. Vette Registries, LLC is independent from GM and is not affiliated
with, sponsored or supported by GM. Copyright/trademark/sales mark
infringements are not intended, or implied and are in fact used to support
GM, Chevrolet and Corvette.
Official C3 Vette Registry content is Copyright 2001-2017, Vette Registries, LLC. Content may not be reused without written consent. All Rights Reserved. NS
Corvette (Vette) Model Years on this site: 1968 1969 1970 1971 1972 1973 1974 1975 1976 1977 1978 1979 1980 1981 1982