I did find one on Corvette Central that looks identical (listed for a 76), but their specs say it is only 6 inches wide; mine is 8 inches. I emailed them to check, but I seldom get responses from any vendor.
If someone has a 76 with this emblem, maybe you could measure it to see if it is actually 8 inches wide.
The link is: https://www.corvettecentral.com/c3-68-82/exterior-trim/emblems/76-rear-bumper-corvette-name-plate-emblem-early-76-293045
Adams' Apple said:Paragonalso carries the 8" version. I thought you needed the 6"....my bad. However...the LATE '75 would have used the 6" version originally. NONE of them('75) had the 8" from the factory.
Thank You! I ordered one.
Question: How do you get to the backside to fasten the nuts? It appears that there is a steel plate about an inch behind where the nuts go, and there is no way I can get my hand back there (the reason I broke the emblem in the first place was I thought it was glued in place and tried to pry it off )
Corvette is a registered trademark of the General Motors Corporation(GM) &
Chevrolet Motor Division. Vette Registries, LLC is responsible for all site content (except for member submitted content or where otherwise
noted) and does not claim or imply that Chevrolet or
GM is responsible for Official C3 Vette Registry content. Vette Registries, LLC is independent from GM and is not affiliated
with, sponsored or supported by GM. Copyright/trademark/sales mark
infringements are not intended, or implied and are in fact used to support
GM, Chevrolet and Corvette.
Official C3 Vette Registry content is Copyright 2001-2018, Vette Registries, LLC. Content may not be reused without written consent. All Rights Reserved. NS
Corvette (Vette) Model Years on this site: 1968 1969 1970 1971 1972 1973 1974 1975 1976 1977 1978 1979 1980 1981 1982