I have rebuilt my 1972 headlight assemblies and had to have some of the housing support hole areas welded on. they were so corroded there was nothing left on some of them. I added metal and redrilled the holes almost level across the plate. I have tried everything, shims all different places etc. The drivers side left front is always low and the right a little high. Shiming the left front, I can't go high enough, it hits the front end fiber glass. I'am to the point that I think I need to buy new ones. It's a 72 LT1 and I wan't it numbers correct. I can't find the original parts# 3915681 & 2. Any ideas to correct my problem, or know where I can get correct ones that are in good shape? Thanks Mountain man
Forgot to mention right side has simllar problems.
Corvette is a registered trademark of the General Motors Corporation(GM) &
Chevrolet Motor Division. Vette Registries, LLC is responsible for all site content (except for member submitted content or where otherwise
noted) and does not claim or imply that Chevrolet or
GM is responsible for Official C3 Vette Registry content. Vette Registries, LLC is independent from GM and is not affiliated
with, sponsored or supported by GM. Copyright/trademark/sales mark
infringements are not intended, or implied and are in fact used to support
GM, Chevrolet and Corvette.
Official C3 Vette Registry content is Copyright 2001-2018, Vette Registries, LLC. Content may not be reused without written consent. All Rights Reserved. NS
Corvette (Vette) Model Years on this site: 1968 1969 1970 1971 1972 1973 1974 1975 1976 1977 1978 1979 1980 1981 1982