Vette(s): 1972 454 Coupe, 4 speed, Targa Blue with blue interior, luggage rack
Picked up a rear window tray in nice condition at Carlisle for my 72. It has the hinges already attached and I have the hinge half that mounts on the bulkhead. My question is what acts as the pivot pin, if you will, between these halfs? See the pictures. The piece that mounts on the car has a threaded nut welded to it. Searched all the usual Corvette supply houses and only Doc Rebuild has anything associated but he has the plastic bushings only. Anyone have pictures from their 68-72? Thanks/member_uploads/10001_10100/10002/6DE6A_rear_window_tray_hinge.jpg.
Vette(s): 1972 Corvette Stingray Coupe, 350 Base engine, p/s, p/b, a/c, automatic. All as original, 55,000 miles.
Here is a pic off the web. I did mine as well but don't have pics, but the tray rotates on the plastic bushing. I used a cardboard box to hold the tray in position while attaching the hinges. Hope this helps a bit.
Corvette is a registered trademark of the General Motors Corporation(GM) &
Chevrolet Motor Division. Vette Registries, LLC is responsible for all site content (except for member submitted content or where otherwise
noted) and does not claim or imply that Chevrolet or
GM is responsible for Official C3 Vette Registry content. Vette Registries, LLC is independent from GM and is not affiliated
with, sponsored or supported by GM. Copyright/trademark/sales mark
infringements are not intended, or implied and are in fact used to support
GM, Chevrolet and Corvette.
Official C3 Vette Registry content is Copyright 2001-2018, Vette Registries, LLC. Content may not be reused without written consent. All Rights Reserved. NS
Corvette (Vette) Model Years on this site: 1968 1969 1970 1971 1972 1973 1974 1975 1976 1977 1978 1979 1980 1981 1982