finally finished painting the 69 and need advise on mounting the side louvers .
is there a trick to mounting the louvers-the assembly manual shows 3/8 diameter holes used for mounting my question--is there a trick to getting the rubber nuts behind the fender--the front two louvers can possibly be held in place using the adjacent louver holes but how do you attach the last two louvers? i have the correct hardware for attaching the louvers but there must be a way other than force the rubber nuts through the 3/8 holes while attached to the louvers.
Vette(s): 70 LT1 coupe, 69 350 HP coupe, 69 390HP 427 coupe, 71 LS5 convert, 85 coupe, 93 coupe
Use a long screw in the plug, and just push it in. Pushing on the lip of the plug makes it fatter, but a screw stretches the plug, making it a little skinnier. It wouldn't hurt to add a little dish soap for lubrication.
Corvette is a registered trademark of the General Motors Corporation(GM) &
Chevrolet Motor Division. Vette Registries, LLC is responsible for all site content (except for member submitted content or where otherwise
noted) and does not claim or imply that Chevrolet or
GM is responsible for Official C3 Vette Registry content. Vette Registries, LLC is independent from GM and is not affiliated
with, sponsored or supported by GM. Copyright/trademark/sales mark
infringements are not intended, or implied and are in fact used to support
GM, Chevrolet and Corvette.
Official C3 Vette Registry content is Copyright 2001-2018, Vette Registries, LLC. Content may not be reused without written consent. All Rights Reserved. NS
Corvette (Vette) Model Years on this site: 1968 1969 1970 1971 1972 1973 1974 1975 1976 1977 1978 1979 1980 1981 1982