I have a seven blade fan of which two blades are bent a little at the tips. The fan has been on the car since I restored it in the early 90's. I am replacing the water pump and all hoses. Do you think I should replace the fan. Water pump was installed on the car in 1989. Ecklers makes a replacement and they also make a six blade aluminum one. What should I do?
What should I check on the clutch while I have it off?
Vette(s): 1976 Corvette Stingray L-48 Automatic Black
Sorry, NW is indeed NorthWest (us in Wa & OR). At this point of replacing your water pump you have plenty of options and now would be the best time to make a fan choice when you get everything taken apart.
Corvette is a registered trademark of the General Motors Corporation(GM) &
Chevrolet Motor Division. Vette Registries, LLC is responsible for all site content (except for member submitted content or where otherwise
noted) and does not claim or imply that Chevrolet or
GM is responsible for Official C3 Vette Registry content. Vette Registries, LLC is independent from GM and is not affiliated
with, sponsored or supported by GM. Copyright/trademark/sales mark
infringements are not intended, or implied and are in fact used to support
GM, Chevrolet and Corvette.
Official C3 Vette Registry content is Copyright 2001-2017, Vette Registries, LLC. Content may not be reused without written consent. All Rights Reserved. NS
Corvette (Vette) Model Years on this site: 1968 1969 1970 1971 1972 1973 1974 1975 1976 1977 1978 1979 1980 1981 1982