Going to finally install a new 3:73 diff in my 82, I have all new U joints (6) that I will replace while I'm there; what else should I change out along the line of bushings? The TA's, Strut rods, Bilsteins etc are all fairly new.
Vette(s): 1969 daytona conv. all original 350 350 380 4 sp w/air..and hard top
Hey Phil..sounds like a fun project..things that can be replaced while in there..hmm..sounds like you have done a good bit back there..I am big on rear wheel bearings..if they check out ok as in end play get the grease tool from MAM..since you have the shafts off its only a little more and you can grease them up..other thing..maybe the rubber fuel lines on the tank..I guess it depends on how far you want to dig..but with the rear out there isn't much left back there..you can do a new spring..it may be best to wait and see what may need replaced before you blow your budget on stuff you can replace..
Corvette is a registered trademark of the General Motors Corporation(GM) &
Chevrolet Motor Division. Vette Registries, LLC is responsible for all site content (except for member submitted content or where otherwise
noted) and does not claim or imply that Chevrolet or
GM is responsible for Official C3 Vette Registry content. Vette Registries, LLC is independent from GM and is not affiliated
with, sponsored or supported by GM. Copyright/trademark/sales mark
infringements are not intended, or implied and are in fact used to support
GM, Chevrolet and Corvette.
Official C3 Vette Registry content is Copyright 2001-2018, Vette Registries, LLC. Content may not be reused without written consent. All Rights Reserved. NS
Corvette (Vette) Model Years on this site: 1968 1969 1970 1971 1972 1973 1974 1975 1976 1977 1978 1979 1980 1981 1982