Vette(s): 1972 conv, 4-speed, 350, 200hp, numbers match, rally wheels, war bonnett yellow w/white top. good condition, nice driver.
While removing the weather strip from my T-tops the weather strip retainer screws were rusty and nasty. As a result I pulled the screws through the fiberglass body of the T-top. Now I have a hole where the screw goes through. Are there repair kits, or something to use to hold the retainer in the fiberglass? THANKS!
Vette(s): 1973 L82 4 Speed Coupe - Very original, well documented driver/survivor. 2016 Bend Regional NCRS Top Flight.
Mark, I've have some luck with JB Weld. Not only to bond but it claims it can be drilled and tapped when cured. Resonably priced so it might be worth a try. If you're going the drill and tap route, I would try it on a test piece to see how it works before to apply to your t-top. Good luck and let us know how you make out.
Corvette is a registered trademark of the General Motors Corporation(GM) &
Chevrolet Motor Division. Vette Registries, LLC is responsible for all site content (except for member submitted content or where otherwise
noted) and does not claim or imply that Chevrolet or
GM is responsible for Official C3 Vette Registry content. Vette Registries, LLC is independent from GM and is not affiliated
with, sponsored or supported by GM. Copyright/trademark/sales mark
infringements are not intended, or implied and are in fact used to support
GM, Chevrolet and Corvette.
Official C3 Vette Registry content is Copyright 2001-2018, Vette Registries, LLC. Content may not be reused without written consent. All Rights Reserved. NS
Corvette (Vette) Model Years on this site: 1968 1969 1970 1971 1972 1973 1974 1975 1976 1977 1978 1979 1980 1981 1982