The plastic cover on steering column which houses the headlight dipper switchs and indicator stalk has perished over time and fallen apart? I have the replacement cover to replace. My problem is the plastic slide which fits inside has fallen out. This actuates the headlights from Hi to Lo beam, and I am not sure what position it should be in to re install? Any help would be great? I can send photos to further explain.
Vette(s): #1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/
Am-Fm/map light National/Regional/Chapter NCRS "Top Flight"
#2-1985 Bright Red/Carmine Cp.L-98/auto
Member: NCRS, NCRS Texas, Corvette Legends of Texas
I believe you have it correctly situated. The curved end(where the part number is in the pic) fits up against the wire end of the switch linkage. The turn signal stalk has a stand-off/post on it that pushes on the other end of the white plastic part. Getting all of it back up in there can be frustrating, or it may just put itself back together. MOST of the ones I've done I've had to fight with at least a little before getting it all back together.
____________________________________ Joel Adams C3VR Lifetime Member #56 My Link
Corvette is a registered trademark of the General Motors Corporation(GM) &
Chevrolet Motor Division. Vette Registries, LLC is responsible for all site content (except for member submitted content or where otherwise
noted) and does not claim or imply that Chevrolet or
GM is responsible for Official C3 Vette Registry content. Vette Registries, LLC is independent from GM and is not affiliated
with, sponsored or supported by GM. Copyright/trademark/sales mark
infringements are not intended, or implied and are in fact used to support
GM, Chevrolet and Corvette.
Official C3 Vette Registry content is Copyright 2001-2018, Vette Registries, LLC. Content may not be reused without written consent. All Rights Reserved. NS
Corvette (Vette) Model Years on this site: 1968 1969 1970 1971 1972 1973 1974 1975 1976 1977 1978 1979 1980 1981 1982