Vette(s): #1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/
Am-Fm/map light National/Regional/Chapter NCRS "Top Flight"
#2-1985 Bright Red/Carmine Cp.L-98/auto
Member: NCRS, NCRS Texas, Corvette Legends of Texas
Dave....are the holes in the head that the pushrods go thru circular, or are they slotted, as in they have flats on the sides? If the pushrod holes are completely round....you're not going to be able to run those rockers without installing guide plates. IF the pushrods holes have flat sides, then yer good to go. The reason is that you have to have some way to hold the rocker arms squared on the valve tips. If the pushrod holes are completely round, there is nothing to guide the rods, and hold them in line. The slotted type holes are to guide the rods. Without the slotted holes, you need guide plates. Just something you need to check before finishing up on the rockers....
____________________________________ Joel Adams C3VR Lifetime Member #56 My Link
Corvette is a registered trademark of the General Motors Corporation(GM) &
Chevrolet Motor Division. Vette Registries, LLC is responsible for all site content (except for member submitted content or where otherwise
noted) and does not claim or imply that Chevrolet or
GM is responsible for Official C3 Vette Registry content. Vette Registries, LLC is independent from GM and is not affiliated
with, sponsored or supported by GM. Copyright/trademark/sales mark
infringements are not intended, or implied and are in fact used to support
GM, Chevrolet and Corvette.
Official C3 Vette Registry content is Copyright 2001-2018, Vette Registries, LLC. Content may not be reused without written consent. All Rights Reserved. NS
Corvette (Vette) Model Years on this site: 1968 1969 1970 1971 1972 1973 1974 1975 1976 1977 1978 1979 1980 1981 1982