Vette(s): 1975 Stingray Coupe
2014 Stingray Convertible
I hope I can attach a picture. I am rebuilding my motor and I canít remember what went into the hole. Donít know if it is oil sending unit or just a bolt. Please help me me. Close to firing back up.
It is just beliw the driver side of the distributor. I canít seem to down load a picture. How do I do it so you can see it.
THANK YOU SO VERY MUCH FOR YOUR HELP YOU ALL ARE GREAT.
Vette(s): 1972 conv, 4-speed, 350, 200hp, numbers match, rally wheels, war bonnett yellow w/white top. good condition, nice driver.
It is also the fitting to attach the plastic oil pressure line when you have a gauge in the cluster in the center stack in the passenger compartment. MOST of the sender units I've seen are mounted down by the oil filter. Never one configured like the one in the picture. If it works then it's good to go.
Corvette is a registered trademark of the General Motors Corporation(GM) &
Chevrolet Motor Division. Vette Registries, LLC is responsible for all site content (except for member submitted content or where otherwise
noted) and does not claim or imply that Chevrolet or
GM is responsible for Official C3 Vette Registry content. Vette Registries, LLC is independent from GM and is not affiliated
with, sponsored or supported by GM. Copyright/trademark/sales mark
infringements are not intended, or implied and are in fact used to support
GM, Chevrolet and Corvette.
Official C3 Vette Registry content is Copyright 2001-2018, Vette Registries, LLC. Content may not be reused without written consent. All Rights Reserved. NS
Corvette (Vette) Model Years on this site: 1968 1969 1970 1971 1972 1973 1974 1975 1976 1977 1978 1979 1980 1981 1982