Vette(s): #1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/
Am-Fm/map light National/Regional/Chapter NCRS "Top Flight"
#2-1985 Bright Red/Carmine Cp.L-98/auto
Member: NCRS, NCRS Texas, Corvette Legends of Texas
If I'm seeing your measurements correctly, t appears the "new" dist has a slightly larger diameter than the "old" one. As long as the o-ring fits snug against the intake, you're good to go. The clamp holds the dist down square against the intake.
____________________________________ Joel Adams C3VR Lifetime Member #56 My Link
Vette(s): 1981 Corvette Coupe, Stock, Black on Black,
O.K., thank you.
I thought that an O-ring should be there but my original didn't have one or the new didn't either. I see no groove on the orig. and new distributors. I looked at the Parts Manual and Assembly Manual also. Did not find an O-ring referenced.
Are there any resources for the O-ring for an 1981-350?
Corvette is a registered trademark of the General Motors Corporation(GM) &
Chevrolet Motor Division. Vette Registries, LLC is responsible for all site content (except for member submitted content or where otherwise
noted) and does not claim or imply that Chevrolet or
GM is responsible for Official C3 Vette Registry content. Vette Registries, LLC is independent from GM and is not affiliated
with, sponsored or supported by GM. Copyright/trademark/sales mark
infringements are not intended, or implied and are in fact used to support
GM, Chevrolet and Corvette.
Official C3 Vette Registry content is Copyright 2001-2018, Vette Registries, LLC. Content may not be reused without written consent. All Rights Reserved. NS
Corvette (Vette) Model Years on this site: 1968 1969 1970 1971 1972 1973 1974 1975 1976 1977 1978 1979 1980 1981 1982