Had my pipes made from the header collectors back and everything went well. Car is very quiet with the stock mufflers. May have to do something there in the future. But the real problem is my accelerator pump on the quadrajet. Since I owned this car i have only put 1500 miles in the past 4 years and just had the carb rebuilt about 3 weeks ago. When it was being rebuilt with the napa echlin carb kit I was told the accelerator pump was very flimsy and didnt appear to be good quality. I have always been a napa guy but this is the 4th pump since i owned it. Does anyone know where i can get one that is good quality. I know filco used to make good carb kits but I dont have anyone around here that sells them. another question is can the ethanol from fuel being causing this issue? Again the pump was very flimsy and I could see where it wouldnt hold up. I will also check the pump bore to make sure it has no burrs. i wanted to stay with the quadrajet because it give great fuel economy. Thanks Rodney
It's a shame about Napa. They used to be top quality and their prices reflected that. They are still my main "go to" but any other shop has equal quality stuff . I guess to compete they lowered their standards. That has been the undoing of many companies. I've only been doing a couple of carb rebuilds a year and I do most of my business with Napa but luckily haven't had the same experience. I'd call around to see what other local shops might stock. Plunger quality should be obvious without breeching the kit wrapper (automatically disqualifying it from a return) Good luck on that Rodney. let us know how things turn out.
Jimmy B. Just can't wait to get on the road again.
GOOGLE ROCHESTER QUADRAJET, EDELBROCK HAS ONE THAT IS SHORTER THAN STOCK #1982, WHICH SQUIRTS A LITTLE MORE FUEL THAN STOCK?, IF YOUR HAPPEY WITH STOCK LOOK AROUND, NAPA STUFF FOR THE MOST PART IS MADE OVERSEA'S NOW, IF YOU HAVE TO REPLACE ALL THE TIME, " FORGET BOUT IT", THEY NOT HARD TO REPLACE, GOOD LUCKanips2010-06-04 09:47:46
Hi everybody!! You want to see a blue pump cup. The black one srink when they go dry.
I did mine 4or5 years ago and went to NAPPA. It had a bule cup. Can you see in the top and does the gas spary good. Is your eng. stock Is idle set right. Do the idle screws work? Has the carb went dry. If you dont start it every week or so It could dry out. All ways a bad thing dont let them dry out. So keep em wet seya 81ZOOMZOOM
Corvette is a registered trademark of the General Motors Corporation(GM) &
Chevrolet Motor Division. Vette Registries, LLC is responsible for all site content (except for member submitted content or where otherwise
noted) and does not claim or imply that Chevrolet or
GM is responsible for Official C3 Vette Registry content. Vette Registries, LLC is independent from GM and is not affiliated
with, sponsored or supported by GM. Copyright/trademark/sales mark
infringements are not intended, or implied and are in fact used to support
GM, Chevrolet and Corvette.
Official C3 Vette Registry content is Copyright 2001-2018, Vette Registries, LLC. Content may not be reused without written consent. All Rights Reserved. NS
Corvette (Vette) Model Years on this site: 1968 1969 1970 1971 1972 1973 1974 1975 1976 1977 1978 1979 1980 1981 1982