Any of you folks around the Portland/Vancouver area know of a local carb shop that can handle Q-jets? I performed a minor rebuild on mine with a kit, but I think I want an expert to take a look if possible. I'd want someone to take the top off and check things like the needle and seat and float level, etc. Also looking for advice regarding a possible need to up primary jet size or change rods. The carb is bone stock now, but the car has dual exhaust and the EGR removed. Thanks.
1976 Silver/Firethorn. L48, 4spd. Original 2 bolt, vortec heads, 9.4:1 CR, Speed Pro Cam: email@example.com, 112 LSA, Eagle Steel Crank.
Corvette is a registered trademark of the General Motors Corporation(GM) &
Chevrolet Motor Division. Vette Registries, LLC is responsible for all site content (except for member submitted content or where otherwise
noted) and does not claim or imply that Chevrolet or
GM is responsible for Official C3 Vette Registry content. Vette Registries, LLC is independent from GM and is not affiliated
with, sponsored or supported by GM. Copyright/trademark/sales mark
infringements are not intended, or implied and are in fact used to support
GM, Chevrolet and Corvette.
Official C3 Vette Registry content is Copyright 2001-2018, Vette Registries, LLC. Content may not be reused without written consent. All Rights Reserved. NS
Corvette (Vette) Model Years on this site: 1968 1969 1970 1971 1972 1973 1974 1975 1976 1977 1978 1979 1980 1981 1982