Vette(s): 1969 roadster, 350/350, 4spd, factory side exhaust
Joined: 11/5/2013
Posts: 8
I found some original codes marked in grease pencil on my 69. One area behind the drivers seat under the carpet has a N14 (which I know is side mount exhaust) and the number 262 above it. Under the car right in front of the gas tank also is written 262. Does anyone know what that number means? I don't see it in the Black Book. Is there some source for all the original options that were put on a Vette during manufacture kind of like the Marti report for Mustangs? Thanks for any help. -Mark
Vette(s): 1969 roadster, 350/350, 4spd, factory side exhaust
Joined: 11/5/2013
Posts: 8
I found this on another forum. Looks like it's a work order number.
I believe the number you found is the 'job number'. At the beginning of the body line the workers developed an 'in-house' numbering sequence that ran from 1 to 500. It also appears on the engine compartment side of the passengers foot well, and on the gas tank side of the rear bulkhead. It appears, as well, in pencil on the tank sheet.
Vette(s): 1978 Silver Anniversary
NCRS Five-Star Bowtie
50th Corvette Anniversary Display, Nashville, TN
1978 Pace Car VIN 2324 L82/M21
Joined: 10/16/2002
Posts: 82
MMJ said: I found this on another forum. Looks like it's a work order number.
I believe the number you found is the 'job number'. At the beginning of the body line the workers developed an 'in-house' numbering sequence that ran from 1 to 500. It also appears on the engine compartment side of the passengers foot well, and on the gas tank side of the rear bulkhead. It appears, as well, in pencil on the tank sheet.
Mark
My guess is that it is the job number. While the use of the job number began to change in the 1970s, in the late 1960s, it was typical of the job number to be written on body panels so during body assembly, all the parts would go together. The job number was only used in the body shop and was not a work order number. In 1973, the job number was printed along with RPOs, broadcast codes, schedule data and other information on the buildsheet.
Here's a link to a two-page excerpt from my buildsheet book that describes job numbers, body panels and buildsheet. Its introduced with a 1973 job number on the passenger side underbody panel...as you describe. I am not sure which years but the early C3s had a shield over the underbody panel that, ironically protected the quality of the hand-written grease pencil number.
Now, the only place that confirms your job number would be the tank sticker and...as you described penciled onto it.
Corvette is a registered trademark of the General Motors Corporation(GM) &
Chevrolet Motor Division. Vette Registries, LLC is responsible for all site content (except for member submitted content or where otherwise
noted) and does not claim or imply that Chevrolet or
GM is responsible for Official C3 Vette Registry content. Vette Registries, LLC is independent from GM and is not affiliated
with, sponsored or supported by GM. Copyright/trademark/sales mark
infringements are not intended, or implied and are in fact used to support
GM, Chevrolet and Corvette.
Official C3 Vette Registry content is Copyright 2001-2018, Vette Registries, LLC. Content may not be reused without written consent. All Rights Reserved. NS
Corvette (Vette) Model Years on this site: 1968 1969 1970 1971 1972 1973 1974 1975 1976 1977 1978 1979 1980 1981 1982
30