While reassembly of the front suspension of my 74, I put new front brakes on. I noticed while pushing the pistons back into the calipers that the pistons seemed to have flexible or pivoting heads. I have never seen that before on any other car I have ever put brakes on. was this standard or do i have other problems? It seems as though it is designed that way to keep even pressure on the pad while braking?
Vette(s): #1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/
Am-Fm/map light National/Regional/Chapter NCRS "Top Flight"
#2-1985 Bright Red/Carmine Cp.L-98/auto
Member: NCRS, NCRS Texas, Corvette Legends of Texas
Yes, the caliper pistons will "flop" some inside the bores. There are springs on the backside of the pistons, to hold a small amount of pressure on the pads, to keep them close/touching the rotors at all times. The overall diameter of the pistons is such that only the area that holds the actual seals is even close to the diameter of the piston bore. The areas ahead of, and behind the seals is quite smaller in diameter, unlike most caliper pistons, which are a fairly uniform diameter all the way down. You don't have a "problem", as far as that goes....that's the way they are made.
____________________________________ Joel Adams C3VR Lifetime Member #56 My Link
Corvette is a registered trademark of the General Motors Corporation(GM) &
Chevrolet Motor Division. Vette Registries, LLC is responsible for all site content (except for member submitted content or where otherwise
noted) and does not claim or imply that Chevrolet or
GM is responsible for Official C3 Vette Registry content. Vette Registries, LLC is independent from GM and is not affiliated
with, sponsored or supported by GM. Copyright/trademark/sales mark
infringements are not intended, or implied and are in fact used to support
GM, Chevrolet and Corvette.
Official C3 Vette Registry content is Copyright 2001-2018, Vette Registries, LLC. Content may not be reused without written consent. All Rights Reserved. NS
Corvette (Vette) Model Years on this site: 1968 1969 1970 1971 1972 1973 1974 1975 1976 1977 1978 1979 1980 1981 1982