Vette(s): black 1982 coupe slate gray interior, 350 crossfire, 1985 fuel pump, Steeroids R&P conversion
OK Guys, I need some advise here on something. I have replaced all of my park brake hardware some time back and have piddled with getting everything adjusted but all the procedures I can find state that Im to turn the star wheel until the brake rotor is locked and then back off 7 - 8 teeth. The problem is that even with my park brakes OFF and the car in Neutral (Automatic Trans) I still have trouble turning the rotor, it requires real effort to turn it by hand. I think part of the problem is that the suspension is "hanging" with the trailing arms pulled fully down by the rear spring. Will it make any difference in the effort needed to turn the rotor if the T-arm were at "drive height"? I believe it would but without removing the rear transverse spring (which I dont want to do..been there, done that once before) I dont know how to keep the T-arms at drive height without jacking something up. Where do I put the jack to raise the T-arms without damaging something?
Corvette is a registered trademark of the General Motors Corporation(GM) &
Chevrolet Motor Division. Vette Registries, LLC is responsible for all site content (except for member submitted content or where otherwise
noted) and does not claim or imply that Chevrolet or
GM is responsible for Official C3 Vette Registry content. Vette Registries, LLC is independent from GM and is not affiliated
with, sponsored or supported by GM. Copyright/trademark/sales mark
infringements are not intended, or implied and are in fact used to support
GM, Chevrolet and Corvette.
Official C3 Vette Registry content is Copyright 2001-2017, Vette Registries, LLC. Content may not be reused without written consent. All Rights Reserved. NS
Corvette (Vette) Model Years on this site: 1968 1969 1970 1971 1972 1973 1974 1975 1976 1977 1978 1979 1980 1981 1982