I am in the process of rebuilding the front end of my 73. I have been unable to remove or loosen the bolts holding the upper control arms onto the frame. The nuts are off and the arm can slide down the bolt but the fan shroud is in the way for removal of the arm (both driver and passenger).
My question is: how are the bolts removed, do I just have to use more torque?
finally arrived and rarin' to ride
- SAVE THE WAVE -
Vette(s): #1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/
Am-Fm/map light National/Regional/Chapter NCRS "Top Flight"
#2-1985 Bright Red/Carmine Cp.L-98/auto
Member: NCRS, NCRS Texas, Corvette Legends of Texas
Do NOT try to turn those bolts! They are splined to fit tightly into the frame bracket without spinning, and they are pressed in. To get them loosened/removed, re-install the nut(s) back onto them until flush with the end of the bolt. Then use a shallow socket on the nut end, and a decent sized persuader(eg: hammer) to knock them out. It's definitely a tight fit to swing a hammer in, but that's about the only way to do it, unless you want to remove the shroud.
____________________________________ Joel Adams C3VR Lifetime Member #56 My Link
Corvette is a registered trademark of the General Motors Corporation(GM) &
Chevrolet Motor Division. Vette Registries, LLC is responsible for all site content (except for member submitted content or where otherwise
noted) and does not claim or imply that Chevrolet or
GM is responsible for Official C3 Vette Registry content. Vette Registries, LLC is independent from GM and is not affiliated
with, sponsored or supported by GM. Copyright/trademark/sales mark
infringements are not intended, or implied and are in fact used to support
GM, Chevrolet and Corvette.
Official C3 Vette Registry content is Copyright 2001-2017, Vette Registries, LLC. Content may not be reused without written consent. All Rights Reserved. NS
Corvette (Vette) Model Years on this site: 1968 1969 1970 1971 1972 1973 1974 1975 1976 1977 1978 1979 1980 1981 1982