I'm getting ready to redo my seats (1975). I bought seat heaters and I'm wondering how they get installed. Usually they just go on the foam under the covers, but my seats have these metal wires thar slip into sleaves on the covers that have clips that go through the foam to another wire under the foam. Do I just poke a hole in the heater to allow the clips to pass through them?
Vette(s): 1980 Black on Black 4speed
17x9 rear, 17x8 front with 255-50R-17 Nitto tires
OBX Stainless Steel sidepipes
DeWitts radiator with dual electric fans
I bought some seat heaters but haven't installed them yet. The ones i purchased do allow you to put holes in it as long as it does not disrupt the coil's electrical flow. Some use a coil wire, while others use a carbon fiber grid pattern. If you look on places like Summit racing, they have instructions for that product you can view which has a section on how it can be cut.
Corvette is a registered trademark of the General Motors Corporation(GM) &
Chevrolet Motor Division. Vette Registries, LLC is responsible for all site content (except for member submitted content or where otherwise
noted) and does not claim or imply that Chevrolet or
GM is responsible for Official C3 Vette Registry content. Vette Registries, LLC is independent from GM and is not affiliated
with, sponsored or supported by GM. Copyright/trademark/sales mark
infringements are not intended, or implied and are in fact used to support
GM, Chevrolet and Corvette.
Official C3 Vette Registry content is Copyright 2001-2018, Vette Registries, LLC. Content may not be reused without written consent. All Rights Reserved. NS
Corvette (Vette) Model Years on this site: 1968 1969 1970 1971 1972 1973 1974 1975 1976 1977 1978 1979 1980 1981 1982