Home page
SPONSOR AD SPONSOR AD

Topic: vacuum diagrams

in Forum: All Vettes Discussion


vacuum diagrams

Posted: 9/23/07 5:59am Message 1 of 3
Lifetime MemberLifetime Member
Send PM
Lanoka Harbor, NJ - USA
Joined: 12/21/2006
Posts: 828
Vette(s): 1975 metallic blue coupe with t-tops,L48, t/t steering, black leather interior. 1990 L98, white/red leather interior, auto,a/c
does anyone know where i can find vacuum diagrams for my 90 vette. can't seem to find the whole layout in one diagram. thanks


LIFETIME MEMBER #97
THE DYNAMIC DUO


SPONSOR AD:: (Our Sponsors help support C3VR)

vacuum diagrams

Posted: 9/23/07 7:48am Message 2 of 3
Profile Pic
Lifetime MemberLifetime Member
Moderator
Send PM
Duncanville, TX - USA
Joined: 11/8/2003
Posts: 20214
Vette(s): #1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/ Am-Fm/map light National/Regional/Chapter NCRS "Top Flight" #2-1985 Bright Red/Carmine Cp.L-98/auto Member: NCRS, NCRS Texas, Corvette Legends of Texas
If the service manual doesn't have what ya need, I can check Mitchel & Alldata Monday.
Anything specific you are looking for, or just a complete diagram?


Joel Adams
C3VR Lifetime Member #56    

My Link


(click for Texas-sized view!)
             NCRS

"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"

vacuum diagrams

Posted: 9/23/07 6:55pm Message 3 of 3
Lifetime MemberLifetime Member
Send PM
Lanoka Harbor, NJ - USA
Joined: 12/21/2006
Posts: 828
Vette(s): 1975 metallic blue coupe with t-tops,L48, t/t steering, black leather interior. 1990 L98, white/red leather interior, auto,a/c
thanks joel. the service manual for the 75 shows a complete vacuum diagram so you can trace the lines out and they have them for different carb setups.  on my 90 even though it is running it is not running as it should. i thought i had it narrowed down to the egr solenoid not functioning properly. have tried getting a replacement and there is a national backorder and gm has discontinued them. it felt like it was sticking and holding the egr open that is why i was going to replace it. as there is no vacuum to it with the car idling as the computer shuts the solenoid off, someone mentioned that maybe there is too much vacuum going to it. i pulled the vacuum line going to the solenoid and it shows no vacuum at all. i am trying to back trace the vacuum lines and determine where the vacuum is supposed to come from. there is another solenoid by the charcoal purge tank that a few vacuum lines go thru. to see the system laid out complete would give me a better understanding of the route the vacuum takes. the service manual for the 90 i can only find the diagrams for different components (such as the cruise control servo). hope this makes some kind of sense. thanks again for any help.


LIFETIME MEMBER #97
THE DYNAMIC DUO


in Forum: All Vettes Discussion


SPONSOR AD: (Our Sponsors help support C3VR)