two bolts left and the body is coming off all came out without alot of trouble just some wd40 and some hard wrenchin' till' #4 body mounts the caps for the nut were rusted off. so it leaves to guess where to go from here. try to cut them out with a sawzall or torch em' i was thinking about putting a vise grip on the nut inside the body and try wrenching on it again?!!. any help and/or experience in this problem would be appreciated. 

I don't think the vise grip trick will work. Several of us on here have had the same issue and the consensus is to simply cut them from the bottom. I don't think I'd use a torch though. It's an awfully tight space and too close to the glass for that kind of heat. I cut mine with a die grinder. Just cut the nut off the bottom and you're there!

One word...Dremel...I used about 15 of the little disk but well worth it. 

I used a recip saw and cut right through the bolt..  had to go through the metal spacers..  no problems though

i had to use a dremel on the drivers #2 mount bolt..  and it went well also..