Topic: Drivers Side Mirror
in Forum: C3 Body
Already a Member?
Click Here to Login
Not yet a Member?
Click Here to Register for Free!
Does anyone know how to adjust the drivers side mirror from being too loose? I have to adjust the mirror all the time. Seems to get worse that faster you go.
SPONSOR AD:: (Our Sponsors help support C3VR)
"a small center punch mark at four points around the ball does the trick as well and still allows you to adjust it."
Go into SEARCH - "enter "wandering Mirror" - see the solutions suggested
Big Al

How bout a loose sports mirror? My whole assembly is loose not just the mirror glass. If I take the door panel off is there a screw to tighten the assembly? cilrah 38875.7155555556
MARK
LIFETIME MEMBER #117
Click here to see my new friend P-Racer
"Keep up the Pace"

Moderator
Duncanville, TX - USA
Joined: 11/8/2003
Posts: 20214
Vette(s): #1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/
Am-Fm/map light National/Regional/Chapter NCRS "Top Flight"
#2-1985 Bright Red/Carmine Cp.L-98/auto
Member: NCRS, NCRS Texas, Corvette Legends of Texas
Yes. Should be two of them, Mark.
In order to "punch" the mirror retainer(s), you have to remove the glass. Soak the entire mirror assy. in laquer thinner, or carb cleaner, for a day or so. This will loosen the silly-cone adhesive that holds the glass to the mirror. Then you can lay the mirror on a couple of blocks of wood, covered with towels, or some form of cusions. Then, tap on the rivits that hold the retainers to the mirror. You have to be carefull not to hit it too hard, as you can dimple the back of the mirror. That will tighten the mirror to the base.
Once you have it tightened up, clean the mirror, and the glass of all old sillycone, and reattatch the glass with new sillycone at the four locations provided, and let it set for a day, to completely set up.
In order to "punch" the mirror retainer(s), you have to remove the glass. Soak the entire mirror assy. in laquer thinner, or carb cleaner, for a day or so. This will loosen the silly-cone adhesive that holds the glass to the mirror. Then you can lay the mirror on a couple of blocks of wood, covered with towels, or some form of cusions. Then, tap on the rivits that hold the retainers to the mirror. You have to be carefull not to hit it too hard, as you can dimple the back of the mirror. That will tighten the mirror to the base.
Once you have it tightened up, clean the mirror, and the glass of all old sillycone, and reattatch the glass with new sillycone at the four locations provided, and let it set for a day, to completely set up.

Joel Adams
C3VR Lifetime Member #56
My Link
(click for Texas-sized view!) NCRS
"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"
in Forum: C3 Body
SPONSOR AD: (Our Sponsors help support C3VR)