Topic: 82 wiring hrness question
in Forum: C3 Electrical
Already a Member?
Click Here to Login
Not yet a Member?
Click Here to Register for Free!
I have an 82crossfire vette, I am going to eliminate the cross fire becuase of performance up grades.
Can I still use the factory dash harness to run the vehicle?
Can I still use the factory engine harness also?
Do you recomend I change both? If so will an earlier vette harness work or aftermarket?
Thanks
SPONSOR AD:: (Our Sponsors help support C3VR)

Moderator
Duncanville, TX - USA
Joined: 11/8/2003
Posts: 20214
Vette(s): #1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/
Am-Fm/map light National/Regional/Chapter NCRS "Top Flight"
#2-1985 Bright Red/Carmine Cp.L-98/auto
Member: NCRS, NCRS Texas, Corvette Legends of Texas
The harnesses will be fine. All you need is a 12v supply for the ignition to the distributor, which is already there.
You'll also need to install a bypass, or some other way of turning on the fuel pump. It runs off of the ignition signal, and oil pressure. There are some other '82 folks here that will have more info on this.
You'll need to do something with the fuel pump, tho...it may put out too much pressure for a carb, so you may need a pressure regulator.
What types of mods are you planning, anyway?

You'll need to do something with the fuel pump, tho...it may put out too much pressure for a carb, so you may need a pressure regulator.
What types of mods are you planning, anyway?
Joel Adams
C3VR Lifetime Member #56
My Link
(click for Texas-sized view!) NCRS
"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"
What Joel said is exactley what I did on mine. I have an '85 fuel pump which puts out too much pressure so I used a pressure regulator and a gauge at the carb. I left all the wires in place, no sence digging it all out when you do not have to.
Dave
Lifetime Member #116
Dave's '82
in Forum: C3 Electrical
SPONSOR AD: (Our Sponsors help support C3VR)