Home page
SPONSOR AD SPONSOR AD

Topic: Check Engine Light not working................

in Forum: C3 Electrical


Check Engine Light not working................

Posted: 5/9/04 6:54am Message 1 of 15
Lifetime MemberLifetime Member
Send PM
Brockport, NY - USA
Joined: 1/2/2003
Posts: 44
Vette(s): 1982 Collector Edition
Have replaced the circuit wiring for all the gauges but CHECK ENGINE LIGHT does not come on. Where can I get a replacement check engine assembly?

Any and all help appreciated......
Thanks,
Dan |cheers| |bouncy|


SPONSOR AD:: (Our Sponsors help support C3VR)

Check Engine Light not working................

Posted: 5/9/04 5:16pm Message 2 of 15
Profile Pic
Lifetime MemberLifetime Member
Moderator
Send PM
CUYAHOGA FALLS, OH - USA
Joined: 12/2/2003
Posts: 6424
Vette(s): 1975 C3 Red, T-Tops, Black Interior. All I need is time and money! Getting there!
I presume your car is a 81 or 82, or it would not have a yellow check engine light. Is this the one your talking about? If so, the computer controls the check engine light. Many have a lamp driver that the computer signals to turn on the light. The lamp drivers did fail sometimes, but not often. Check all of the fuses first. It may not be the same as the gauge fuses, but a computer fuse. Let me know and we'll dig a bit.


Check Engine Light not working................

Posted: 5/9/04 6:06pm Message 3 of 15
Lifetime MemberLifetime Member
Send PM
Brockport, NY - USA
Joined: 1/2/2003
Posts: 44
Vette(s): 1982 Collector Edition
Yes the vette is an 82 collector edition.
I will check the fuses and let you know.
Thanks for the help.
Dan |cheers| |bouncy|


Check Engine Light not working................

Posted: 5/9/04 6:07pm Message 4 of 15
Lifetime MemberLifetime Member
Send PM
Brockport, NY - USA
Joined: 1/2/2003
Posts: 44
Vette(s): 1982 Collector Edition
Are the computer fuses located in the same place the fuses are?

Dan


Check Engine Light not working................

Posted: 5/10/04 7:08am Message 5 of 15
Profile Pic
Lifetime MemberLifetime Member
Moderator
Send PM
CUYAHOGA FALLS, OH - USA
Joined: 12/2/2003
Posts: 6424
Vette(s): 1975 C3 Red, T-Tops, Black Interior. All I need is time and money! Getting there!
Yes they are, but are not labeled for the computer. So just make sure they are all good. I will dig up a wiring diagram to locate the colors on the light module. Silly question, did you check the bulb? I know that's a lot of work to get in the dash.


Check Engine Light not working................

Posted: 5/10/04 7:33pm Message 6 of 15
Lifetime MemberLifetime Member
Send PM
Brockport, NY - USA
Joined: 1/2/2003
Posts: 44
Vette(s): 1982 Collector Edition
checked bulb and was ok.
will check fuses.
Dan |cheers| |thumb|


Check Engine Light not working................

Posted: 5/11/04 11:40am Message 7 of 15
Profile Pic
Lifetime MemberLifetime Member
Moderator
Send PM
CUYAHOGA FALLS, OH - USA
Joined: 12/2/2003
Posts: 6424
Vette(s): 1975 C3 Red, T-Tops, Black Interior. All I need is time and money! Getting there!
I did some checking. You do have a remote lamp driver module in the wiring harness. This usually behind the dash, but I did not find the exact location.

I printed out the trouble shooting flow chart and wiring diagram for the lamp and lamp driver. Send me your address and I will drop it in the mail. Much easier than trying to duplicate it all here. Besides, I could get into some copyright law if I posted it verbatim.

The lamp gets it's power from the 20a trans fuse. If you ground the D terminal at the ALDL (computer diagnostic link) the light should come on. This is a yellow wire. If not the problem is in the power supply to the bulb, or the ground wire from the bulb.

If it does come on the problem is now in the wire from the ALDL to the lamp driver, the lamp driver itself, or the computer control, or associated wiring.

It sounds like a lot, but it's not that bad. When you see the diagram you will see what I mean.


Check Engine Light not working................

Posted: 5/11/04 8:19pm Message 8 of 15
Lifetime MemberLifetime Member
Send PM
Brockport, NY - USA
Joined: 1/2/2003
Posts: 44
Vette(s): 1982 Collector Edition
dan donovan
234 harvest dr
rochester ny 14626-1330 |cheers|


Check Engine Light not working................

Posted: 5/12/04 8:09am Message 9 of 15
Profile Pic
Lifetime MemberLifetime Member
Moderator
Send PM
CUYAHOGA FALLS, OH - USA
Joined: 12/2/2003
Posts: 6424
Vette(s): 1975 C3 Red, T-Tops, Black Interior. All I need is time and money! Getting there!
In the mail today.


Check Engine Light not working................

Posted: 5/16/04 8:01am Message 10 of 15
Lifetime MemberLifetime Member
Send PM
Brockport, NY - USA
Joined: 1/2/2003
Posts: 44
Vette(s): 1982 Collector Edition
Ken,
Just wanted to update you on progress so far.........
Tested the check engine light by jumping the d or 419 terminal on aldl and grounded it to shifter and light came on.
So am in progress of removing the computer so i can check the connections to see if there are any loose fitting ones.
waiting for your mail to arrive.

thanks for the help so far...........
Dan |cheers|


in Forum: C3 Electrical


SPONSOR AD: (Our Sponsors help support C3VR)