Home page
SPONSOR AD SPONSOR AD

Topic: Door lock connection

in Forum: C3 Electrical


Door lock connection

Posted: 6/6/04 1:05pm Message 1 of 17
Former Member
Send PM
Joined: 4/28/2004
Posts: 16
Restoring my 1982 vette and got a problem with the connection of the door locks |sad|. Because they were not working took the doorpanels off and found several connections loose. Can't find right colorcabels go where, not even in the shop manual.

Hope some one knows. Thanks.


SPONSOR AD:: (Our Sponsors help support C3VR)

Door lock connection

Posted: 6/6/04 1:48pm Message 2 of 17
Former Member
Send PM
COLUMBUS, MS - USA
Joined: 1/11/2004
Posts: 331
Vette(s): 1972 Coupe; 350 4-speed with GM sidepipes; Classic White/Saddle
The lock switch for the driver's door should have five wires attached to it:

orange = hot
black = ground - should run from driver's switch to passenger's switch
light blue = power to passenger's switch from driver's switch
tan = power to lock motors
gray = power to lock motors

Hope this helps.

John

|UPDATED|6/6/2004 1:48:49 PM (AZT)|/UPDATED|



Door lock connection

Posted: 6/7/04 1:55pm Message 3 of 17
Former Member
Send PM
Joined: 4/28/2004
Posts: 16
Thanks Jhon,

But where goes which color ?? I got 5 entries in the 'socket' where the doorlock switch connects to the wiring.Actually some wires came lose while I was working on the locks and I forgot the right way to connect them back. |eek|

Regards, Theo


Door lock connection

Posted: 6/8/04 4:29am Message 4 of 17
Former Member
Send PM
COLUMBUS, MS - USA
Joined: 1/11/2004
Posts: 331
Vette(s): 1972 Coupe; 350 4-speed with GM sidepipes; Classic White/Saddle
The tan and gray are run "side-by-side", the black and light blue run "side-by-side", the orange runs alone. Do you have spade terminals, round pins or another type of connection on the switch itself?

John


Door lock connection

Posted: 6/12/04 2:27pm Message 5 of 17
Former Member
Send PM
Joined: 4/28/2004
Posts: 16
Hi John,
Hope you can help me out here. I'm working on the connections for more than a year now and can't figure out which color wire connects to where. The left and right are different as mentioned in the shop manual.
For the connections are factory standard, round pins on the switch side and round holes on the doorharness side.

Switches lookes like this:_______X__X_____(X = pin)
(pin setup when looked at)__X__X__X

Hope you can tell me more on this |smile| .

Theo


Door lock connection

Posted: 6/24/04 3:40pm Message 6 of 17
Former Member
Send PM
Joined: 3/22/2004
Posts: 179
Vette(s): 1982 COLLECTOR EDITION
Hey Theo,
I think John has you straightened out on this problem. If you guys can't get it I happen to have the door panels off my '82 right now,but I am not at home at this moment.Let me know if you need me to look.
Jules |idea|


Door lock connection

Posted: 6/26/04 2:00pm Message 7 of 17
Former Member
Send PM
Joined: 4/28/2004
Posts: 16
Would be great if you had a look. I know all the wires which are which as Jhon explained but I'm missing the right place of the wire connections in the (sealed) connector at the end (that's where the doorswitches are placed into). I know it's easier to order a replacement wiring at Eckler's but I want the original setup to work. |bouncy|


Door lock connection

Posted: 6/28/04 2:24pm Message 8 of 17
Former Member
Send PM
Joined: 3/22/2004
Posts: 179
Vette(s): 1982 COLLECTOR EDITION
Theo,
I Will have a look tonight and post again later on or tomorrow.
Jules |thumb|


Door lock connection

Posted: 6/28/04 4:24pm Message 9 of 17
Former Member
Send PM
Joined: 3/22/2004
Posts: 179
Vette(s): 1982 COLLECTOR EDITION
O.K. Theo,
Here's how the wires go.Turning the switch around and looking directly at the back with the proper up and down orientation,I see three wires on the left side,Black at the top,the next wire down is tough to tell the color but could be a discolored white,very light grey,or even tan,and the bottom one is blue.On the right side are the remaining two wires with orange on top and grey on the bottom,so if you started with the black wire on top left and went counterclockwise it would be black, white?,blue,grey,and orange.Hope you can work it out.
Jules |cheers|


Door lock connection

Posted: 6/30/04 1:44pm Message 10 of 17
Former Member
Send PM
Joined: 4/28/2004
Posts: 16
Thanks Jules,

That's the information I'm looking for. It took me almost a year to figure this out.
I'll try it out later this week and let you know. |thumb|

Theo


in Forum: C3 Electrical


SPONSOR AD: (Our Sponsors help support C3VR)