Home page

C3 Electrical

Need picture of starter harness to main harness (1/1)
 2/4/19 12:35am
BacaBill
Standard Member
Send Private Message

Toms River, NJ - USA

Vette(s):
'79 L82 4spd


Joined: 3/24/2003
Posts: 105

Hey guys & gals,, been a long time since I've been on here, mostly because the Vette has been sitting AGAIN. I had a meltdown at the connector where the main harness plugs into the starter harness (against firewall next to the distributor) on my '79. Can anyone get a detailed pic of the harness connectors at that point? Seems like I have a couple extra wires. It's the 6pin connector with 8 wires (2 are doubled up) going into it. PS: I also did away with the little brown connector right next to it,, no longer have A/C in the car. Thanx in advance,,, Bill A

|UPDATED|2/3/2019 9:35:44 PM (AZT)|/UPDATED|


______________
EdelBrock Performer w/ 750 doub pumper,port/polished heads, triple cut valves w/4th cut down the throat of the exhaust valves, 286 Comp Magnum cam, 1.6 roller rockers, ball-peen pushrods w/guides, screw in rocker studs w/girdles, Comp double-roller chain, , hi-rise valves covers w/ spacer (needed for the girdles), Flowtech by Holley long-tube ceramic coated headers into Stage II pipes (no cats), chrome wire looms for the MSD 8.5 mm wires, MSD 50,000v coil kit w/advance springs, cap, rotor, module, steel-braided radiator,heater,vacuum hoses, Infinity Kappa 4x6 plates (dash), Sony Xplode 6 3/4" (rear), chrome T-stat housing, A-arm shields, B&M Hammerhead shifter |IMG||/IMG|
Our Sponsors help support C3VR
Sponsor Ad