Topic: Temperature Gauge
in Forum: C3 Electrical
Already a Member?
Click Here to Login
Not yet a Member?
Click Here to Register for Free!
Does anyone know the correct installation of the water temperature gauge for a 69? There is a small insulating washer, a ceramic bar insulator and a strip resistor and I can find no clear instructions on what goes where. I know where the wiring terminals go, but that's it. HELP!!!
SPONSOR AD:: (Our Sponsors help support C3VR)
Former Member
Send PM
Mounds View, MN - USA
Joined: 5/24/2007
Posts: 1031
Vette(s): 70 LT1 coupe, 69 350 HP coupe, 69 390HP 427 coupe, 71 LS5 convert, 85 coupe, 93 coupe
I looked at our used parts. Only one gauge still had the parts on it, but it had the ceramic going from the top to the bottom terminal, and the washer, then resistor on the right side as viewed from the back.
I couldn't find a reference to verify that, but it looks right.
Larry
I couldn't find a reference to verify that, but it looks right.
Larry

Moderator
Duncanville, TX - USA
Joined: 11/8/2003
Posts: 20214
Vette(s): #1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/
Am-Fm/map light National/Regional/Chapter NCRS "Top Flight"
#2-1985 Bright Red/Carmine Cp.L-98/auto
Member: NCRS, NCRS Texas, Corvette Legends of Texas
The service manual should show the correct configuration, I think...
The description Larry provides does sound right, but I haven't looked at the back-side of early gauges in years, so I'm of no use with this one.
The description Larry provides does sound right, but I haven't looked at the back-side of early gauges in years, so I'm of no use with this one.

Joel Adams
C3VR Lifetime Member #56
My Link
(click for Texas-sized view!) NCRS
"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"
in Forum: C3 Electrical
SPONSOR AD: (Our Sponsors help support C3VR)