Home page
SPONSOR AD

Topic: Windshield wiper switch hard to move

in Forum: C3 Electrical

Windshield wiper switch hard to move

Posted: 11/2/20 8:41pm Message 1 of 2
Profile Pic
Standard Member
Send PM
Cana, VA - USA
Joined: 7/3/2016
Posts: 372
Vette(s): 1975 Stingray 71 350 engine Flat top pistons Sniper fuel injection Hyperspark ignition Vintage Air air conditioning Borgeson power steering box

The windshield wiper switch on my 75 is hard to move -- almost impossible to push it to the Low position without it going right to the Hi position,  I have had 3 or 4 switches in this car and they are all about the same.  Is this typical of these switches, or is there something I can do for it?




   

SPONSOR AD:: (Our Sponsors help support C3VR)

Re: Windshield wiper switch hard to move

Posted: 11/3/20 7:25pm Message 2 of 2
Profile Pic
Lifetime MemberLifetime Member
Moderator
Send PM
Duncanville, TX - USA
Joined: 11/8/2003
Posts: 20214
Vette(s): #1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/ Am-Fm/map light National/Regional/Chapter NCRS "Top Flight" #2-1985 Bright Red/Carmine Cp.L-98/auto Member: NCRS, NCRS Texas, Corvette Legends of Texas

Can't say that I have ever run into one that was "hard" to move from one position to another. Best suggestion I have would be to maybe try to spray a little WD40 into it and work it back/forth, or maybe make sure the switch is not being bound up when you screw it to the dash panel? Are they all hard to manipulate OUT of the dash also?




Joel Adams
C3VR Lifetime Member #56    

My Link


(click for Texas-sized view!)
             NCRS

"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"

in Forum: C3 Electrical


SPONSOR AD: (Our Sponsors help support C3VR)