Topic: wiring help on a '69
in Forum: C3 Electrical
Already a Member?
Click Here to Login
Not yet a Member?
Click Here to Register for Free!
On my wiper motor, left side, there's a wiring plug with yellow blue and black wires, there's also a short black wire with a male butt connector on it. I have looked and looked, but I can't find where the male butt connector plugs into! Any help appreciated.
Thanks,
Matt
Thanks,
Matt
SPONSOR AD:: (Our Sponsors help support C3VR)
Don't think it's a ground wire, there's a spade type black wire on top of the wiper motor. This one is part of the plug that goes to the pump. There's a blue wire, yellow wire and 2 black wires. The black wire in question comes out of the plug, is about 6" long and has a male butt connector on it.
Thanks,
Matt
Thanks,
Matt
No, just hi lo.
Matt
Matt
Former Member
Send PM
COLUMBUS, MS - USA
Joined: 1/11/2004
Posts: 331
Vette(s): 1972 Coupe; 350 4-speed with GM sidepipes;
Classic White/Saddle
Is there some part of the system that's not working?
'69 should have two yellow wires (together), one black/orange and one light blue plugged to the wiper motor. One of the yellows will run to the firewall (with light blue and black/orange). The other yellow should be connected to the washer pump, along with a white/darkblue that also runs to the firewall.
Any of this sound familiar?
John
'69 should have two yellow wires (together), one black/orange and one light blue plugged to the wiper motor. One of the yellows will run to the firewall (with light blue and black/orange). The other yellow should be connected to the washer pump, along with a white/darkblue that also runs to the firewall.
Any of this sound familiar?

John
I'am looking at my 69 service manual, you have a red wire going to a red- white wire going to the micro switch,black-pk and black from wiper motor to what looks like the 3 blade terminal board,next to the terminal board on the right there is a small hex head screw that attaches a L shaped gounding spade, on my 72 I have two black pigey backed ground wires attached to the L spade,the manual doesn't show washer wiring or how many ground wires to the L spade,I might have missed something its late,hope this helps, wiring sucks!
the single black wire go to L spade on washer cover ! It is a ground wire . the other end should be on the bell housing near the starter !! The 3/8 opening is often put on the starter stud by mistake !!!! This open a bag of worms!!!!!!





Hot Springs, AR - USA
Joined: 4/24/2004
Posts: 3236
Vette(s): 69 Conv #'s match 427, TKO-600/.64, 3.36HD-Posi, HT, T/T, PS, PB, PW, SP, Leather, Comp XE264HR & Roller Rockers & Lifters, Air-Gap RPM intake, Holley St Av 770 VS, MSD 6AL+Dist+Blaster SS, K&N, Jet-Hot Hooker Side-Pipes, Steeroids, Al Rad, Spal Fans
yeah do your self a favor with this wire..
cut the end off and put a 1/4" end on it.. then connect it to the starter REAR bracket stud.
cut the end off and put a 1/4" end on it.. then connect it to the starter REAR bracket stud.
in Forum: C3 Electrical
SPONSOR AD: (Our Sponsors help support C3VR)