Home page
SPONSOR AD SPONSOR AD

Topic: Need brake advice

in Forum: C3 Engines, Driveline and Handling


Need brake advice

Posted: 2/28/09 5:43am Message 1 of 4
Former Member
Send PM
williamston, NC - USA
Joined: 1/19/2006
Posts: 353
Vette(s): 1969 coupe, 350, m22 trans, ac, black on black,
 Thursday I noticed a small amount of brake fluid on my left rear tire. The car is a 69 coupe and had not been driven in a few weeks.I had not pumped the brakes either( My screw up). I removed the tire and pumped the brakes, I could see a drop of fluid after about 5 ms. I have pumped the brakes for the last couple of days and have not seen anymore fluid so far. My question is ,will the fluid swell the o rings and reseat them or do I need to do a caliper rebuild. The car had just had new stainless steel calipers put on it when I purchased it, 4 yrs ago. never any problems before. I also noticed that the brake fluid in the resivoir was cloudy, any reason for that?,I also dont know what brand of brake calipers were installed, no marking on them, I think they are Van Steel brand but If I have to get a rebuild kit, I dont know which one to get. My car came from Arizona and Im in N.C. Help!  Rick d


SPONSOR AD:: (Our Sponsors help support C3VR)

Need brake advice

Posted: 2/28/09 6:53am Message 2 of 4
Profile Pic
Former Member
Send PM
Frederick, MD - USA
Joined: 9/8/2003
Posts: 3398
Vette(s): 1969 convertible L71 427/435 4-speed black interior
If you're seeing any brake fluid at all anywhere other than inside the master cylinder, you have a problem. Get that caliper tended to. Whether it to be rebuilt, replaced, a hose replaced, etc. It's simply too important to put off.

If the fluid is cloudy, have the whole system purged of fluid and have it flushed and filled with all fresh fluid. If it's cloudy, it's contaminated.


Need brake advice

Posted: 3/1/09 5:54am Message 3 of 4
Former Member
Send PM
williamston, NC - USA
Joined: 1/19/2006
Posts: 353
Vette(s): 1969 coupe, 350, m22 trans, ac, black on black,
 Thanks for the reply, Gunslinger,I have already ordered a new caliper and master cylinder from Eklers, When I looked at the master cylinder I saw rust in the bottom of it, so I took it out, I will flush her out good and try again, I ordered me one of those 1 man bleeder vacumn tools, I let you know how she works, Rd


Need brake advice

Posted: 3/2/09 8:49am Message 4 of 4
Former Member
Send PM
Mounds View, MN - USA
Joined: 5/24/2007
Posts: 1031
Vette(s): 70 LT1 coupe, 69 350 HP coupe, 69 390HP 427 coupe, 71 LS5 convert, 85 coupe, 93 coupe
A common mistake is thinking that since you don't drive the car, the brakes don't need attention.  In fact, if you don't drive the car several thousand miles per year, you should bleed the brakes every two or three years.  Driving warms up the fluid and boils out any moisture.  Sitting lets the moisture rot the seals, so no amount of pumping will fix them.  But if you bleed regularly, your breaks should last indefinitely.

Larry



in Forum: C3 Engines, Driveline and Handling


SPONSOR AD: (Our Sponsors help support C3VR)