By mistake took of the rear high pressure port fitting - out cam a "lpunger and a spring. Now I know the spring goes in first followed by this "plunger" One und of the plunger fits nicely into the spring - while the other end is larger in diameter looks like it would nest upon the high pressure port hardware forlimg a double piston arrangment.
Any one confirm the position of this "plunger" - small end into spring or reverse
Thanks
Al

Without looking, it sounds like you have it correct. Small end in the spring.

|UPDATED|9/18/2004 1:15:16 PM (AZT)|/UPDATED|

Ken:
RIGHT as ALWAYS
I was in a parts store and looked at a parts catalog- Just as you said - small end in spring - not that I doubted you but since I was in the store buying "necessary supplies" I took a look
Thanks
Al

You're welcome