Topic: Rag Joint
in Forum: C3 Engines, Driveline and Handling
Already a Member?
Click Here to Login
Not yet a Member?
Click Here to Register for Free!
Former Member
Send PM
Beechhurst, NY - USA
Joined: 11/23/2003
Posts: 8
Vette(s): 1981 Silver/Blue Baldwin Motion Coversion
97 Nassau Blue C5
anyone have any suggestions on how to remove the old rag joint from the coupler. or where I can find a new coupler
thanks
|UPDATED|3/6/2004 5:01:39 PM (AZT)|/UPDATED|
thanks
|UPDATED|3/6/2004 5:01:39 PM (AZT)|/UPDATED|
|img|http://temp.corvetteforum.net/c3/electricblue/PicsfrowebPage/vetteb2_1_.jpg|img|
SPONSOR AD:: (Our Sponsors help support C3VR)
Lifetime MemberRemoval is not that bad. Remove the bolts from both sides, and spread the joint over the shaft with a screwdriver or chisel. Then slide the ends off of the shafts. You may need to loosen the steering column and raise it an inch or two to get clearance, but sometimes you can get it off without moving the column.
New ones should be available from several sources. Wilcox, etc.
Ken Styer
New ones should be available from several sources. Wilcox, etc.
Ken Styer
in Forum: C3 Engines, Driveline and Handling
SPONSOR AD: (Our Sponsors help support C3VR)