Home page
SPONSOR AD SPONSOR AD

Topic: Speedometer cable

in Forum: C3 Engines, Driveline and Handling


Speedometer cable

Posted: 3/10/03 11:06am Message 1 of 8
Former Member
Send PM
SIGNAL MOUNTAIN, TN - USA
Joined: 2/2/2002
Posts: 8
Vette(s): 79 Red L-48 all stock, 26,000 original miles
My '79 speedometer quit working and I suspect one of the two cables is broken as the needle began jumping just prior to quiting.

I have removed the front bezel on the instument panel and the allen screws holding the speedometer faceplate. But I am reluctant to pull the faceplate forward to get access to the back of the speedometer in fear of bending it or distorting it. Any tips?

Secondly, how can one tell whether the upper or lower cable is the bad actor?

Thanks in advance. |bouncy|


SPONSOR AD:: (Our Sponsors help support C3VR)

Speedometer cable

Posted: 3/10/03 4:42pm Message 2 of 8
Lifetime MemberLifetime Member
Send PM
Joined: 1/29/2002
Posts: 1049
Charlie, check out this link. I personally have never done it, but I printed this out in case I have to
Chris
http://www.corvettemagazine.com/2000/october/cable/speedp1.asp


Speedometer cable

Posted: 3/10/03 5:11pm Message 3 of 8
Former Member
Send PM
SIGNAL MOUNTAIN, TN - USA
Joined: 2/2/2002
Posts: 8
Vette(s): 79 Red L-48 all stock, 26,000 original miles
Thanks for the article. I will absorb it and comment. |thumb|


Speedometer cable

Posted: 5/16/03 1:08pm Message 4 of 8
Former Member
Send PM
Joined: 5/15/2003
Posts: 110
Vette(s): 1979 Black on Black, heavily modified. 1975 Orange, bone stock (for now).
Remove the cables from the trasducer and see if you can slide the inner steel wire out. |cheers|


|B|JOIN THE 1979 CORVETTE REGISTRY! |/B| |URL|http://www.vettefinders.com/79registry/ |/URL| |IMG|http://www.vettefinders.com/79registry/homesivu_tiedostot/79regyla01_tiedostot/bannerthe.gif |/IMG| |URL|www.c3-r.com|/URL|

Speedometer cable

Posted: 7/24/03 5:35pm Message 5 of 8
Former Member
Send PM
Sandusky, OH - USA
Joined: 9/21/2002
Posts: 4
Vette(s): 1979 L-82 WHITE/RED ALL THE OPTS.
I have a 79 vette also same proublem found it to be a bad transducer, Disconect cable from it (The cable that goes from the transducer to your speed-o- meter) and spin it to see if the needel moves. If it moves you know that cable is good. Than take the other cable loose from both ends and spin it, if it spins I would say its your transducer.
Good Luck
mortsvette@aol.com

|UPDATED|7/24/2003 5:35:19 PM|/UPDATED|



Speedometer cable

Posted: 7/25/03 10:02am Message 6 of 8
Profile Pic
Lifetime MemberLifetime Member
Moderator
Send PM
Burke, VT - USA
Joined: 1/23/2002
Posts: 7313
Vette(s):
SOLD - "The Toy" - '70 Convertible
SOLD - "The Beast" - '90 ZR-1 (#682)
SOLD - "Betty" - '28 Ford Model A Tudor
SOLD - "BLKBRRD" - '78 Pontiac Trans Am
"BLUBYU" - '04 Coupe
On the way back from BG (somewhere in northern Illinois) the odometer gave it up on "The Toy" so I'm going to be tearing into this towards the fall. The speedo continues to work, but the miles just don't click over. Hopefully I can get the trip meter working as well with this project.


Jim Olson 

"The Toys"...!!!  Save the Wave!

Where I've been in a Corvette...!!!

Speedometer cable

Posted: 7/25/03 11:29am Message 7 of 8
Lifetime MemberLifetime Member
Moderator
Send PM
BINGHAMTON, NY - USA
Joined: 7/19/2003
Posts: 3808
Vette(s): ......
I had that problem when I first got my 78 , no speedo the lower cable from tranny was broken off inside the transducer,had to get the transducer out of the car that was a pain,the little plastic end of the speedo cable was jambed inside the imput shaft of the unit ,had to carefully drill the plastic so not to tear up the brass inside the imput shaft then pick out the rest.cleaned up the inside of the transducer put it back together,put in a new cable,and wala it works. try it |thumb| |wavey| |saluteflag|


C3VR Lifetime Member #93

Speedometer cable

Posted: 8/26/03 12:48pm Message 8 of 8
Former Member
Send PM
Joined: 8/26/2003
Posts: 22
Vette(s): 1980 CORVETTE
Mine did this last year and it was the cable going from the transducer to the transmission. I have to cables going into the transducer . top one goes to the speedometer and bottom one goes to the transmission. |thumb| |thumb|


in Forum: C3 Engines, Driveline and Handling


SPONSOR AD: (Our Sponsors help support C3VR)