Home page
SPONSOR AD

Topic: Engine misfire? - multiple cylinders not firing?

in Forum: C3 Engines

Engine misfire? - multiple cylinders not firing?

Posted: 12/29/14 6:58pm Message 1 of 3
Profile Pic
Former Member
Send PM
taylors, SC - USA
Joined: 12/7/2014
Posts: 3
Vette(s): 1979 Corvette Dark Green all original 60,000 miles
Hello Forum members I have an interesting problem that I hope isn't serious.  I have a 1979 L48 with just over 60k miles.  When I bought the car, about 500 miles ago, the car would spit carbon out the exhaust pipes at initial start up.  I changed the plugs to the correct heat range, AC Delco R45TS and everything was great.  I recently went to start the car and go for a spin but the car was running really rough and would stall on me.  It seemed as though the engine was flooded because I would have to keep the pedal to the floor in order to keep the engine running to limp it back inside the garage.  I opened up the hood and was moving the spark plug wires thinking they may be loose and noticed something really strange.  The #3, 4, 6 and 7 cylinder headers were hot but the rest were slightly warm at best.  Any ideas on what's wrong?  Hopefully I just need a tune-up.  

Any and all comments and suggestions are greatly appreciated.  Thanks in advance for your replies.

Phil



SPONSOR AD:: (Our Sponsors help support C3VR)

Re: Engine misfire? - multiple cylinders not firing?

Posted: 12/29/14 8:31pm Message 2 of 3
Profile Pic
Lifetime MemberLifetime Member
Moderator
Send PM
Duncanville, TX - USA
Joined: 11/8/2003
Posts: 20214
Vette(s): #1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/ Am-Fm/map light National/Regional/Chapter NCRS "Top Flight" #2-1985 Bright Red/Carmine Cp.L-98/auto Member: NCRS, NCRS Texas, Corvette Legends of Texas
Sounds like you either have a carb problem, or something with the ignition. Since you seem to have dead, or mis-firing on the 1-8-5-2 cylinders, but the 3-4-6-7 cylinder are firing, it appears that you have one side of the carb not feeding fuel into the intake properly. Think I would remove all the plugs, and see what they look like.
I think you'll prolly wind up removing the carb and having a look at it, or just rebuild it.


Joel Adams
C3VR Lifetime Member #56    

My Link


(click for Texas-sized view!)
             NCRS

"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"

Re: Engine misfire? - multiple cylinders not firing?

Posted: 12/29/14 8:34pm Message 3 of 3
Profile Pic
Standard Member
Send PM
Grapevine, TX - USA
Joined: 8/26/2006
Posts: 1522
Vette(s): 1972 LT-1 convertible with factory air. 2017 Black Rose Grand Sport convertible.
Bad dist. cap or rotor?  Bad wires?  Bad plugs?


   

in Forum: C3 Engines


SPONSOR AD: (Our Sponsors help support C3VR)