Home page
SPONSOR AD

Topic: engine start

in Forum: C3 Engines

engine start

Posted: 9/28/09 8:41pm Message 1 of 8
Former Member
Send PM
Fresno, TX - USA
Joined: 1/15/2007
Posts: 240
Vette(s): 1980 corvette
What is the reason the car is harder to start when hot? When I first get in the car is turns over very fast and starts right up. When it has been ran and I cut it off and then try to start it it wants to grunt  a few times then turn over and start. 


  
SPONSOR AD:: (Our Sponsors help support C3VR)

engine start

Posted: 9/29/09 3:57am Message 2 of 8
Profile Pic
Former Member
Send PM
goldens bridge, NY - USA
Joined: 11/3/2003
Posts: 498
Vette(s): 1972 T-Top 350 auto, matching numbers,Blue, ac

Starter could be getting hot from engine heat and when you try to restart - it doesn't have the "guts" it had when it was cold .

I'm sure others will have other suggestions - gas, spark

Big Al





engine start

Posted: 9/29/09 5:08am Message 3 of 8
Profile Pic
Lifetime MemberLifetime Member
Moderator
Send PM
Duncanville, TX - USA
Joined: 11/8/2003
Posts: 20214
Vette(s): #1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/ Am-Fm/map light National/Regional/Chapter NCRS "Top Flight" #2-1985 Bright Red/Carmine Cp.L-98/auto Member: NCRS, NCRS Texas, Corvette Legends of Texas
Sounds like you may have a timing issue...as in too much initial timing. That's what normally makes them "grunt" when starting hot. It could also be carbon build-up on the pistons, so-so fuel, or too much piston/cylinder wall clearance.
I'd suggest checking the timing first. The advance weights in the distributor may be sticking, too...check the timing cold and hot, to see if there is a major difference.



Joel Adams
C3VR Lifetime Member #56    

My Link


(click for Texas-sized view!)
             NCRS

"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"

engine start

Posted: 9/29/09 5:17am Message 4 of 8
Former Member
Send PM
Fresno, TX - USA
Joined: 1/15/2007
Posts: 240
Vette(s): 1980 corvette
well may I also say it has a small cam?


  

engine start

Posted: 9/29/09 10:08am Message 5 of 8
Profile Pic
Lifetime MemberLifetime Member
Moderator
Send PM
Duncanville, TX - USA
Joined: 11/8/2003
Posts: 20214
Vette(s): #1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/ Am-Fm/map light National/Regional/Chapter NCRS "Top Flight" #2-1985 Bright Red/Carmine Cp.L-98/auto Member: NCRS, NCRS Texas, Corvette Legends of Texas
You may...
Even more reason to check the ignition timing. Do you happen to have the specs on the cam?



Joel Adams
C3VR Lifetime Member #56    

My Link


(click for Texas-sized view!)
             NCRS

"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"

engine start

Posted: 9/29/09 10:27am Message 6 of 8
Former Member
Send PM
Fresno, TX - USA
Joined: 1/15/2007
Posts: 240
Vette(s): 1980 corvette
guess I can find them I was told it was a small cam


  

engine start

Posted: 9/29/09 10:52am Message 7 of 8
Profile Pic
Former Member
Send PM
Oak Creek, WI - USA
Joined: 5/21/2008
Posts: 1965
Vette(s): 1981 Great White Shark. Red Interior, 350/190 hp. PS, PB (SS), A/C CC, T-Tops. Served three years in Active Duty Army, then Retired Air Force after 34 years! Badger State Vettes Car Club. 175,000 Original miles!! Now own a 1998 C-5!
Is your 1980 a California Car?  Does it have the ECM?


engine start

Posted: 9/29/09 12:48pm Message 8 of 8
Former Member
Send PM
Fresno, TX - USA
Joined: 1/15/2007
Posts: 240
Vette(s): 1980 corvette
not for sure the cam was put in to my understanding


  

in Forum: C3 Engines


SPONSOR AD: (Our Sponsors help support C3VR)