Topic: hard turnover when warm
in Forum: C3 Engines
Already a Member?
Click Here to Login
Not yet a Member?
Click Here to Register for Free!
Here's an interesting one....my newly rebuilt 350/350 SB with a 222 degree cam in my '72 auto starts and runs fine. The battery is good and the starter turns the engine over plenty fast...but after getting it warmed up, if I stop for gas, let's say, and go to restart, it bearly turns over....like the battery is almost dead.
But, once its gets one revolution over, it kicks right in and runs fine...so don;t tell me my timing is too advanced, because this is different from a hard starting engine...this is a "hard to turn over" engine!....
Reminds me of an air cooled airplane engine where the alum pistons immediately lock up inside the cyldrs after shutdown due to differental cooling...
So, I was thinking it may be the starter getting hot since it is close to my headers...would a hot starter loose power? any other ideas?
Thanks, Bill
SPONSOR AD:: (Our Sponsors help support C3VR)

Moderator
Duncanville, TX - USA
Joined: 11/8/2003
Posts: 20214
Vette(s): #1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/
Am-Fm/map light National/Regional/Chapter NCRS "Top Flight"
#2-1985 Bright Red/Carmine Cp.L-98/auto
Member: NCRS, NCRS Texas, Corvette Legends of Texas
That's a very distinct possibility. If the engine is not "kicking back", as if too much timing, and it spins & starts ok after one revolution, I'd say there could be a starter problem.
Joel Adams
C3VR Lifetime Member #56
My Link
(click for Texas-sized view!) NCRS
"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"
Former Member
Send PM
The Woodlands, TX - USA
Joined: 1/27/2006
Posts: 67
Vette(s): 1969 Coupe, Red, L88 Tribute
Are you running headers??? You starter maybe getting heat soaked due to the headers. There are starter wraps or guards that can be installed on the starter to help with this problem. If you backoff the timing a couple of degrees, it will probably help as well.
Steve
SMSCORVETTE


You can also get a heat sheild to attach to the starter to help keep it cool. Or look into a small bocy high torque starter. These cure the problem very nicely.
in Forum: C3 Engines
SPONSOR AD: (Our Sponsors help support C3VR)