What are the ups and downs of installing headers on my 74 corvette small block??? Ive only had them on Chevelles and Nova's. What about the heat factor?? Anything i should know or look out for before installing? Any and all info or opinions would be greatfully appreciated.

Thanks.............

|UPDATED|2/28/2004 2:44:22 PM (AZT)|/UPDATED|

No downsides that you haven't already had with the other cars. All good. There are some earlier post about headers you may want to check out.

Ken Styer

I just purchased headers for my 79 but haven't installed them yet. I was told the ceramic coated headers would run alot cooler thus keeping the inside of the car cooler. Once I get them on I'll let you know if it works.

My mechanic recommended that the headers be ceramic coated on my 74, small block (not original engine). I have done that.

Engine temprature running between 160 & 190 (can't say exactly, due to the guage...)

I'm not an expert when it comes to this stuff, but anything to get the engine runnung cooler is a bonus. The headers definately works with the small block - no doubts about that.

Be sure that you ask for ceramic coating and not powder coating. Powder coating will let the engine run hotter.

Regards,
Elmien

|UPDATED|3/1/2004 1:09:23 PM (AZT)|/UPDATED|

I bought DynoMax Ceramic's from Jegs. Cost is $229.00
http://www.jegs.com/cgi-bin/ncommerce3/ProductDisplay?prrfnbr=1283&prmenbr=361

Good Luck - If they don't fit exactly try into place. If that doesnt work get really . Then try again after a few .

Too funny!

I knew there was a correct way to do it LOL