Home page
SPONSOR AD

Support our Vendors!  |  Advertise Here

Topic: How is the hood raised if the Hood release breaks?

in Forum: C3 Engines


Already a Member?
Login
Not yet a Member?
Register for Free!

How is the hood raised if the Hood release breaks? (1/2)
 6/4/21 3:10pm
Babyblue 78
Standard Member
Send Private Message


Vette(s):
1978 Corvette Light Blue Pulled from the swamps of Miami! Its a driver and back on the road!


Joined: 12/3/2007
Posts: 280

In replacing a previous wrong hood release, I wondered if the hood release wire or the nut on the end ever breaks how does one release and open the hood.  Being the car is some 43 years old and I'm sure it's the original metal cable and end nut stop, how would one open the hood in this situation.

 

I'm guessing in the driver front wheel well there is a access panel that can be opened and somehow able to reach in with a pliers and pull down on the release or wire, but not sure.  Not that I ever hope this happens but Murphy does visit once and a while?

 

Thanks for any info for this situation.

 

Babyblue 78



______________

Our Sponsors help support C3VR
Re: How is the hood raised if the Hood release breaks? (2/2)
 6/4/21 4:16pm
73shark
Limited Member
Send Private Message

Overland Park, KS - USA

Vette(s):
1973 Orange Metallic Coupe (orig owner), L82, 4 spd (WR), PS, (A/C & PW (I installed from wrecked 73)), leather, AM/FM Stereo, ran with '65 FI unit earlier & will again some day.


Joined: 7/9/2003
Posts: 864

With the hood open and you look directly behind the driver side latch, you will see a plastic plug in the firewall. That plug/hole gives you access from inside the car with a tool with a hook on it to pull the latch manually. I may be wrong but I seem to remember that there was an aftermarket Corvette supplier that carry such a tool.



______________

1973 L-82 4 spd

Our Sponsors help support C3VR