Home page
SPONSOR AD

Topic: Oil Leak at Oil Filter

in Forum: C3 Engines

Oil Leak at Oil Filter

Posted: 10/27/08 7:22pm Message 1 of 12
Gold MemberGold Member
Send PM
Toms River, NJ - USA
Joined: 7/28/2004
Posts: 116
Vette(s): 1978 Silver Anniversary Coupe Lt. Biege w/ Dark Brown Int. Happily owned since 1981.
Hey Gang, Got another issue I could use some advice on. Changed the oil & filter. Ran for awhile & no leaks. Next day I back her out of the garage & notice a couple of drops of oil on the floor. Looked underneath an saw a small amount of oil ready to drip off the filter. Thought I just didn't tighten the filter well enough, so I wipe it off a tightened it a little more. (1/2 turn w/ oil filter wrench. Good & snug now). Ran for few minutes w/o any leak. Took her for a ride, came back, no leak.  Next day, before I even started her, looked underneath, and there it was. Couple of drips on the floor and another one ready to drop from the filter.
Any Ideas? Thanks ahead of time.



SPONSOR AD:: (Our Sponsors help support C3VR)

Oil Leak at Oil Filter

Posted: 10/27/08 7:27pm Message 2 of 12
Profile Pic
Lifetime MemberLifetime Member
Moderator
Send PM
CUYAHOGA FALLS, OH - USA
Joined: 12/2/2003
Posts: 6424
Vette(s): 1975 C3 Red, T-Tops, Black Interior. All I need is time and money! Getting there!
You may want to pull the filter off and look at the rubber seal.  Sometimes the old seal will stick to the engine, and stay there when the new one is put in place.  This will often create a leak.   I have seen it happen several times.   Just a thought.


Oil Leak at Oil Filter

Posted: 10/27/08 7:31pm Message 3 of 12
Former Member
Send PM
Dutchess County, NY - USA
Joined: 8/27/2007
Posts: 2484
Vette(s): White '79 Corvette. It's a driver.
OK, I'm gonna take a stab at this.
I'd go ahead and drain out the new oil. Save it if you want to.
Chuck the oil filter and get a new one.
Clean around the surface area on the block where the filter gasket meets up with it. (I use a few paper towels.)
Re install the new filter after lubing it and re use or put in new oil.
I'm thinking that the filter is defective or the gasket may have gotten some debris on it that you may not have noticed.
 
That's what I'd try first.
 
Kevin



Oil Leak at Oil Filter

Posted: 10/27/08 7:33pm Message 4 of 12
Former Member
Send PM
Canada
Joined: 6/23/2008
Posts: 558
Vette(s): 1972, 1980
kstyer, good thought...have done this myself, in a rush and not paying attention. If that's not the case though while you have the old one off put on a new filter and see if it stops.


Oil Leak at Oil Filter

Posted: 10/27/08 7:39pm Message 5 of 12
Profile Pic
Lifetime MemberLifetime Member
Send PM
Wichita, KS - USA
Joined: 11/10/2003
Posts: 6859
Vette(s): 2005 Daytona Sunset Orange Metallic Coupe --------------------- Sold 1974 T-top, 4 spd to BillKS

I know this may sound weird, but check to make sure you don't have 2 gaskets on the filter.  The old gasket didn't come off with the filter and I didn't notice.  Wacko   This happened to me years ago and it leaked quite a bit like yours.  Probably not your problem, but you never can tell.   Didn't think it would happen to me either.

Larry



   C3VR Lifetime Member #102                   
    My Link.........          
 
                     
The difference between men and boys is the cost of their toys!!              

Oil Leak at Oil Filter

Posted: 10/27/08 7:56pm Message 6 of 12
Profile Pic
Lifetime MemberLifetime Member
Moderator
Send PM
Duncanville, TX - USA
Joined: 11/8/2003
Posts: 20214
Vette(s): #1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/ Am-Fm/map light National/Regional/Chapter NCRS "Top Flight" #2-1985 Bright Red/Carmine Cp.L-98/auto Member: NCRS, NCRS Texas, Corvette Legends of Texas
Prolly a bad filter...usually, the two gasket scenario will pour quite a bit of oil while running, but not always, so check that first.
Are you certain its new oil? Could it be some of the old oil running down the new filter from the filter adapter? I've seen that many times, too.
If it ain't old oil, or two gaskets, it's prolly a filter leaking at the rolled bead at the top...can you say "Heche en Mexico"? Adams' Apple2008-10-27 19:57:34


Joel Adams
C3VR Lifetime Member #56    

My Link


(click for Texas-sized view!)
             NCRS

"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"

Oil Leak at Oil Filter

Posted: 10/27/08 8:45pm Message 7 of 12
Profile Pic
Lifetime MemberLifetime Member
Moderator
Send PM
Moses Lake, WA - USA
Joined: 4/16/2005
Posts: 2134
Vette(s): 1976 L48 4-spd, Mahogany Metalic exterior, Buckskin interior 350ci/350hp, 3rd owner, fiberglass spring, 255/50-16's Torq-Thrust II
[QUOTE=kstyer]You may want to pull the filter off and look at the rubber seal.  Sometimes the old seal will stick to the engine, and stay there when the new one is put in place.  This will often create a leak. [/QUOTE]
 
 
Happened to me many years ago



Oil Leak at Oil Filter

Posted: 10/28/08 8:18am Message 8 of 12
Former Member
Send PM
Mounds View, MN - USA
Joined: 5/24/2007
Posts: 1031
Vette(s): 70 LT1 coupe, 69 350 HP coupe, 69 390HP 427 coupe, 71 LS5 convert, 85 coupe, 93 coupe
I have to wonder why it doesn't leak while running, but does after it sits.  If it was the filter or its gasket, wouldn't it start leaking while the engine was running and making oil pressure?  Or maybe it just takes that long to run down.  If all else fails, there is dye you can put in your oil, so you can see the source.

Larry



Oil Leak at Oil Filter

Posted: 10/28/08 9:18am Message 9 of 12
Profile Pic
Former Member
Send PM
Victor, NY - USA
Joined: 7/12/2004
Posts: 6841
Vette(s): 2004 Commemorative Edition Coupe, Auto w/HUD. 13K miles in 2015. Sold 1982 Red Coupe
Are you sure it is coming from the filter and not above the filter?


 
Save the Wave!
Support the National Corvette Museum   

Oil Leak at Oil Filter

Posted: 10/28/08 9:26am Message 10 of 12
Lifetime MemberLifetime Member
Send PM
Eastern Oklahoma County, OK - USA
Joined: 1/3/2006
Posts: 1560
Vette(s): 1980 Black L48 T-Tops
I'm w/Dave on this one.  Have you checked the seam @ the head at the back of the engine on the drivers side?  Much like a leaky roof on a house, the point of drip may not necessarily be the area of origin...


in Forum: C3 Engines


SPONSOR AD: (Our Sponsors help support C3VR)