Home page
SPONSOR AD

Topic: Again with the headers

in Forum: C3 Fuel, Emission Control, and Exhaust Systems


Again with the headers

Posted: 3/11/05 11:30pm Message 1 of 5
Lifetime MemberLifetime Member
Send PM
ANCHORAGE, AK - USA
Joined: 10/12/2004
Posts: 2193
Vette(s): 1965-327 coupe, 1968-small block coupe, 1969-427, 1971-454 coupe and currently a 1976-ZZ4 coupe reborn again,and hotter than ever.. Add a 1996 CE LT-4 for backup
I can't seem to find a set of headers that will fit on a ZZ4 engine with aluminum;58cc chambered heads and D-shaped exhaust ports thats going in my 1976. I have found some block huggers, but, not to fit the  D-port shape heads? It's a 4 speed with AC. Could I use round tublar headers on the D-shaped ports without hurting the engine? Does anyone know of a manufacture that supplies what I need? Some of you out there must have these heads on your engine? I'm up here in the North Country the snow is a going and I need to finish this car? What's the answer? So far everything I  have needed has come from the lower 48 states, this will be no exception. come on guys where are they....Terry




   "I Love all Corvettes! LifeTime Member #60..Terry"

SPONSOR AD:: (Our Sponsors help support C3VR)

Again with the headers

Posted: 3/12/05 9:02am Message 2 of 5
Profile Pic
Former Member
Send PM
Frederick, MD - USA
Joined: 9/8/2003
Posts: 3398
Vette(s): 1969 convertible L71 427/435 4-speed black interior
I don't know the answer, but you might contact Summit Racing and ask their techs. You might also contact header manufacturers like Hooker, Hedmen, etc., and see what they say.


Again with the headers

Posted: 4/2/05 11:36am Message 3 of 5
Former Member
Send PM
Mineral Ridge, OH - USA
Joined: 10/30/2004
Posts: 8
Vette(s): 79 L-82--------- ok so zz4 motor still at the interior Nice paint job guys

 Terry,

   Eckler's.com . Hedman Hedders




Again with the headers

Posted: 4/2/05 1:32pm Message 4 of 5
Lifetime MemberLifetime Member
Send PM
ANCHORAGE, AK - USA
Joined: 10/12/2004
Posts: 2193
Vette(s): 1965-327 coupe, 1968-small block coupe, 1969-427, 1971-454 coupe and currently a 1976-ZZ4 coupe reborn again,and hotter than ever.. Add a 1996 CE LT-4 for backup

Thanks kevin and all,

 

I have purchased a set of Sanderson's that are made specific for my aluminum "D"- port heads.....Terry






   "I Love all Corvettes! LifeTime Member #60..Terry"

Again with the headers

Posted: 4/2/05 2:19pm Message 5 of 5
Profile Pic
Lifetime MemberLifetime Member
Moderator
Send PM
CUYAHOGA FALLS, OH - USA
Joined: 12/2/2003
Posts: 6424
Vette(s): 1975 C3 Red, T-Tops, Black Interior. All I need is time and money! Getting there!
You can always check with Hooker.  They should have any combination you need.kstyer38444.5977199074


in Forum: C3 Fuel, Emission Control, and Exhaust Systems


SPONSOR AD: (Our Sponsors help support C3VR)