Home page
SPONSOR AD

Topic: cruise cobntrol

in Forum: C3 Fuel, Emission Control, and Exhaust Systems

cruise cobntrol

Posted: 10/15/07 4:05am Message 1 of 7
Former Member
Send PM
Oviedo, FL - USA
Joined: 9/8/2006
Posts: 267
Vette(s): 1977 t-top
I think I'm about to re post an old question.I have never used cruise control on any car.I wish to remove(and save) what appears to be the cruise control device under driver side fender and the baseball size salvo.Am I looking for trouble by removing these two items? Does anything else have to happen for me to succesfully remove cruise from this 77.Lever on steering column is not a concern.


SPONSOR AD:: (Our Sponsors help support C3VR)

cruise cobntrol

Posted: 10/15/07 5:16am Message 2 of 7
Profile Pic
Lifetime MemberLifetime Member
Moderator
Send PM
Duncanville, TX - USA
Joined: 11/8/2003
Posts: 20214
Vette(s): #1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/ Am-Fm/map light National/Regional/Chapter NCRS "Top Flight" #2-1985 Bright Red/Carmine Cp.L-98/auto Member: NCRS, NCRS Texas, Corvette Legends of Texas
You shouldn't have any problems if you want to remove the under-hood hardware....except for the speed-o. You'll need a different cable to run from the trans to the speed-o head in the dash. You may also need a ratio adapter for the connection on the trans, so the speed-o reading will be accurate.


Joel Adams
C3VR Lifetime Member #56    

My Link


(click for Texas-sized view!)
             NCRS

"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"

cruise cobntrol

Posted: 10/15/07 6:59am Message 3 of 7
Former Member
Send PM
Oviedo, FL - USA
Joined: 9/8/2006
Posts: 267
Vette(s): 1977 t-top
How about this Joel....I leave the cruise mechanism which is under the fender,now I don't have a new speed cable issue,AND I just remove the servo which is the PITA since it is out there on the fender well.Is that doable?


cruise cobntrol

Posted: 10/15/07 7:37am Message 4 of 7
Profile Pic
Former Member
Send PM
Victor, NY - USA
Joined: 7/12/2004
Posts: 6841
Vette(s): 2004 Commemorative Edition Coupe, Auto w/HUD. 13K miles in 2015. Sold 1982 Red Coupe
Why not just leave it there?
What is the reason for removing part of it?



 
Save the Wave!
Support the National Corvette Museum   

cruise cobntrol

Posted: 10/15/07 9:00am Message 5 of 7
Lifetime MemberLifetime Member
Send PM
Joined: 3/31/2007
Posts: 293

I removed mine on the 77,left the transducer ,also about 8ft of vacuum hose.removed Before I did it I tried to fix it but there are no servos available that I could find.The 77 system is a 1 year only.There is 2 rivets holding the servo to the fender.It really cleaned up the engine compartment on the drivers side




cruise cobntrol

Posted: 10/19/07 4:26pm Message 6 of 7
Profile Pic
Lifetime MemberLifetime Member
Send PM
Cadiz, KY - USA
Joined: 8/26/2002
Posts: 249
Vette(s): 74 Convertible
Why not just leave it turned off?


C3VR Life Member #4
NCM Life Member #994
Vietnam Helicopter Pilots Association Life Member

cruise cobntrol

Posted: 10/19/07 7:03pm Message 7 of 7
Profile Pic
Lifetime MemberLifetime Member
Moderator
Send PM
Duncanville, TX - USA
Joined: 11/8/2003
Posts: 20214
Vette(s): #1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/ Am-Fm/map light National/Regional/Chapter NCRS "Top Flight" #2-1985 Bright Red/Carmine Cp.L-98/auto Member: NCRS, NCRS Texas, Corvette Legends of Texas
Apparently, some folks just want to remove some clutter from under the hood. That's fine...especially if the darn thing don't work anyway!

You can remove the servo, and leave the transducer, with no problem, mikeee!!


Joel Adams
C3VR Lifetime Member #56    

My Link


(click for Texas-sized view!)
             NCRS

"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"

in Forum: C3 Fuel, Emission Control, and Exhaust Systems


SPONSOR AD: (Our Sponsors help support C3VR)