I've got the red fibreglass 70 vert very low SN 0035.Well the seat back for the pass side came unglued and I can't get my fingers in there to re-glue it.Has anybody taken one of these apart?If so can you walk me through it.I've got the get the interior part out.I've tried to get to it with the door opened but still no luck.The piece won't come all the way out because of the seat belts.Thanks zgator2007-05-14 16:07:19

Possibly you could expand the subject heading...it took me a few minutes to figure out just what the heck you was talking aboot!
You have a Franklin Mint 1970 car, I finally deduced!!
All of that stuff is just glued in to start with, as far as the seats, and the seatbelts. What you may try, is using a model car glue that comes in a black bottle, with a LONG, needle-like tip. That always works for me in tight spots. If you can get the tip in there, and skwert a little glue on the seatback, then you can use a toothpick, or similar item to push the seatback onto the seat for a few minutes.
Check with your local Hobby Shop, and ax for "Model Master" brand liquid cement, #8872. It's a 1 ounce, black plastic bottle with about an inch long tip. Be carefull with this stuf...a little dab'l do ya!

and, to keep this from happening again...stay away from FM stuff...Danbury is MUCH better, quality-wise, and detail-wise, imho.

I used to be a model maker but not for years now. I wasn't even close to getting this one.

Sorry about that.Most of my stuff is Danbury,they are much better.

Is there A link for these ? I wanna 77

No 77 made by any of the mints.for sure not in fibreglass

Plastic?

Might be able to get a promo off eaby cheap.But their just curb side stuff. Just checked and I don't know how to post a link but here is the item # 230128360909.It's a silver coupe for $9.00 I think.Better hurry,only about a day and a half left.Nice model.If you go into the promo section of ebay under toys hobbies and serch corvette 1977 theres also a red onezgator2007-05-15 17:02:12