Home page
SPONSOR AD SPONSOR AD

Topic: Jack Stand Location

in Forum: C3 General Discussion


Jack Stand Location

Posted: 7/5/10 9:18am Message 1 of 4
Profile Pic
Former Member
Send PM
edgwood, MD - USA
Joined: 11/1/2007
Posts: 736
Vette(s): 1975 convertible,with the hard top and power streering.it a 350 L48 with auto trans. the color is light blue.
 I know this is going to sound silly,but where do you put the jack stand  when you put the rear of the car on stands.I was told by this fellow I was putting them in the wrong place.I put them on the frame just in front of the rear wheels.The only reason that I'm asking is when I have the car on stands(working on the rear of car) my door gaps change.They go back to normal when car is back on the ground.
                                    Thanks Rick


SPONSOR AD:: (Our Sponsors help support C3VR)

Jack Stand Location

Posted: 7/5/10 9:43am Message 2 of 4
Profile Pic
Lifetime MemberLifetime Member
Moderator
Send PM
Duncanville, TX - USA
Joined: 11/8/2003
Posts: 20229
Vette(s): #1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/ Am-Fm/map light National/Regional/Chapter NCRS "Top Flight" #2-1985 Bright Red/Carmine Cp.L-98/auto Member: NCRS, NCRS Texas, Corvette Legends of Texas

(click image for larger pic)
From the FACTORY Service Manual...
Adams' Apple2010-07-05 09:44:33


Joel Adams
C3VR Lifetime Member #56    

My Link


(click for Texas-sized view!)
             NCRS

"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"

Jack Stand Location

Posted: 7/5/10 9:52am Message 3 of 4
Former Member
Send PM
Mounds View, MN - USA
Joined: 5/24/2007
Posts: 1031
Vette(s): 70 LT1 coupe, 69 350 HP coupe, 69 390HP 427 coupe, 71 LS5 convert, 85 coupe, 93 coupe
I had never thought to look at the service manual Joel posted, but have always used exactly those locations.  And yes, the door gaps change.  The frame does flex a little.  Just make sure you are supporting the car in the factory suspension locations if you are working on anything that requires alignment or doing any bodywork.

Larry



Jack Stand Location

Posted: 7/5/10 2:16pm Message 4 of 4
Lifetime MemberLifetime Member
Send PM
Dillsboro, IN - USA
Joined: 8/3/2003
Posts: 182
Vette(s): 1969-427/435hp T top Tri-power 2000-Mag Red six speed convertible

Rick, This is what i would add to Joel's pictures. If i am going to rotate my

tires i use two floor jacks at the points shown at the same time and on the same side but i open the doors first just so they are not latched and on the C5 i also pop the trunk, can't hurt.               Butch
      
 



in Forum: C3 General Discussion


SPONSOR AD: (Our Sponsors help support C3VR)