Home page
SPONSOR AD SPONSOR AD

Topic: Starting a vette for the 1st. time in 12 yrs-TIPS?

in Forum: C3 General Discussion


Starting a vette for the 1st. time in 12 yrs-TIPS?

Posted: 1/30/04 3:47pm Message 21 of 25
Former Member
Send PM
Jacksonville, TX - USA
Joined: 1/29/2004
Posts: 1
Vette(s): 1977 Corvette, blue. Now undergoing total resoration
Over Thanksgiving I pulled a 77 out of the mud where it had been sitting since 1995. I changed the oil and filled the radiator fluid and installed a new battery. With the aid of a little spray on starter fluid, it turned over and started. The water pump was shot so I lost a lot of water, but other than that nothing. I only ran it for short time.
I found that all fluids (brake, rear end, etc) had evaporated away and had to be added. THe brakes were rusted so badly, the calipers had to be replaced, but the MC and booste were fine. I've changed the fuel filter every 1/2 hour of running time since then until I get all the bad gas out. There's a lot of junk coming through.

Hope this helps
Larry - FVIT


SPONSOR AD:: (Our Sponsors help support C3VR)

Starting a vette for the 1st. time in 12 yrs-TIPS?

Posted: 1/30/04 4:51pm Message 22 of 25
Profile Pic
Lifetime MemberLifetime Member
Send PM
Dorr, MI - USA
Joined: 8/21/2002
Posts: 2581
Vette(s): 71 Colonnade Hardtop Coupe Torch Red with black interior originally L48 built to push around 360hp
Hey Larry, Clean out gas tank. Its better than running all the bad gas through the carb. Might save you a carb rebuild. Gas that sits for 30 days will have already started to form bacteria.Imagine what its like after years? Its a must not to run bad gas (varnish) through your carb!


Starting a vette for the 1st. time in 12 yrs-TIPS?

Posted: 1/31/04 10:32am Message 23 of 25
Profile Pic
Lifetime MemberLifetime Member
C3VR Founder
Send PM
Eagleville, PA - USA
Joined: 11/1/2001
Posts: 18595
Vette(s): Used to own a 1979 Corvette now owned by JB79
It looks like you've gotten all the advice you need.... now, you have to make sure you tell us what the results were once you do all of this and finally get it running!

Good Luck! |thumb|


-Adam Wartell
NCM Lifetime Member #1222
Founder: C3 Vette Registry 
C4 Vette Registry, C6 Vette Registry

My first Vette, now owned by JB79:

Starting a vette for the 1st. time in 12 yrs-TIPS?

Posted: 1/31/04 9:25pm Message 24 of 25
Former Member
Send PM
Joined: 1/25/2004
Posts: 16
I will definitely use all these tips, thanks to all. Be on the lookout in May when I try all this good stuff. I will post the results then. Thanks for everything, I'm hooked on this site!
Patrick |cool| |rollysmile| |cool| |rollysmile| |cool| |rollysmile| |cool| |rollysmile| |cool|


1979-White/White, T-TOPS, L48, 195HP.

Starting a vette for the 1st. time in 12 yrs-TIPS?

Posted: 2/1/04 7:16am Message 25 of 25
Former Member
Send PM
Odessa, FL - USA
Joined: 1/31/2004
Posts: 2
Vette(s): 1975 pearl white coupe.
If you don't want to remove the dist. to pre lube the engine, ask your major auto parts supp;y house if they have a pressure pre luber you can borrow/rent. This is a pressurized can that you put the oil in and hook up to the block where your oil pressure line screws in. It will push the oil completely thru your engine without having to remove and then reinstall your dist.
Last time I borrowed one there was no charge just had to leave a deposit until I returned it.

I would also drain the gas or you will have nothing but problems with the stale gas gumming things up. I would also replace all the rubber gas hose anywhere on the gas line from the tank to the carb. Most of the gas line is steel tubing so just check around and replace any rubber that has been installed along the line. It has to be rotten as its probably over 12 years old and you don't want to burn up the entire car for 2 bucks worth of rubber hose, if its all steel don't worry about it.


|URL|C:\My Documents\My Pictures\The White Pearl.jpg |/URL|

in Forum: C3 General Discussion


SPONSOR AD: (Our Sponsors help support C3VR)